GE616 PROXIMITY READER USER’S MANUAL GE616 V5. 2.
GE616 PROXIMITY READER CONTENTS 1. Introduction page 3 2. Identifying supplied parts page 3 3. Specification page 3 4. Installation page 4 5. Wire Color Table of the Reader page 5 6. Wire Connection to Controller page 5 7. Operation page 6 8. FCC Registration Information page 7 9.
GE616 PROXIMITY READER 1. Introduction The GE616 is an elegant looking and an attractive 4" read range proximity reader which can be mounted to metal door frame(mullion) or any flat wall surface. The GE616 use the same electronics module in epoxy potting that ensure you successful operation even in harsh environments. The different bezels allow you to interchange the bezel for different applications or wall conditions.
GE616 PROXIMITY READER 4. Installation 4-1. Mullion/Wall Mount Drill two 6-32 or M3 holes 3.3"(8.38cm) apart in vertical and drill one 1/2" hole for the reader cable 1.7"(4.31cm) apart from the top hole. (If you have installed electric gang box then skip this step.) 4-2. Put reader cable into the center hole and install the reader module by using two 6-32 or M3 screws. 4-3. Put bezel into the reader module then push bezel until you hear the locking sound.
GE616 PROXIMITY READER 5. Wire Color Table of the Reader POWER Power(DC +5V~+17V) DC(+) Power(DC Ground) DC(-)(GND) INPUT Buzzer control input BUZZER LED control input LED OUTPUT(Wiegand Format) Wiegand Data-0 Data-0 Wiegand Data-1 Data-1 OUTPUT(ABA Track II Format) ABA(Card Present) CP ABA(Clock) CLK ABA(DATA) Data OUTPUT(RS232C Format) RS232C(TX) TX Red wire Black wire Blue wire Yellow wire Green wire White wire Orange wire White wire Green wire Violet wire 6.
GE616 PROXIMITY READER 7. Operation 7-1. Apply power and you can see Red LED is on indicating the reader is in standby. 7-2. Present proximity card to the reader until you hear beep sound and the LED is changing the color to Green simultaneously and the reader send RF card data to the controller then LED changes the color to Red again for next reading. 7-3.
GE616 PROXIMITY READER 8. FCC REGISTRATION INFORMATION FCC REQUIREMENTS PART 15 Caution: Any changes or modifications in construction of this device which are not expressly approved by the responsible for compliance could void the user's authority to operate the equipment. NOTE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions; 1. This device may not cause harmful interface, and 2.
GE616 PROXIMITY READER 9. Warranty and Service The following warranty and service information applies only to the United States of America and Republic of Korea. For the information in other countries, please contact your local distributor. To obtain in or out of warranty service, please prepay shipment and return the unit to the appropriate facility listed below. IN THE UNITED STATES RF LOGICS Inc. Service Center 3026 Scott Blvd., SANTA CLARA, CA95054 Tel.: (408) 980-0001 Fax.