i User Manual UniPay III i
ViVOpay UniPay III UserManual 80149500-001 Copyright Copyright 2016, International Technologies and Systems Corporation. All rights reserved. ID TECH 10721 Walker Street Cypress, CA 90630 USA This document, as well as the hardware and software it describes, is furnished under license and may only be used in accordance with the terms of such license. The content of this paper is furnished for informational use, subject to change without notice, and not to be construed as a commitment by ID TECH.
ViVOpay UniPay III UserManual FCC Regulatory Compliance Notices Class B Equipment This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
ViVOpay UniPay III UserManual Table of Contents 1 Overview ...................................................................................................... 1 1.1 1.2 1.3 2 Firmware Upgrade ....................................................................................... 6 2.1 2.2 3 4 5 Additional Features ......................................................................................... 1 ViVOpay UniPay III Specifications ............................................................
1 1 Overview The ViVOpay® UniPay III supports card swipe, contact and contactless payment information processing and authorization at mobile devices. The unit can accept a variety of contactless credit cards, contactless key Fobs.
ViVOpay UniPay III UserManual 1.2 ViVOpay UniPay III Specifications Hardware MTBF 200,000 hrs. Transmitter Frequency 13.56 MHz +/- 0.01% Transmitter Modulation ISO 14443-2 Type A Rise/Fall Time: 2-3 µsec. Rise, < 1 µsec fall ISO 14443-2 Type B Rise/Fall Time: < 2 µsec. each; 8% - 14% ASK ISO 18092 Receiver Subcarrier Frequency 847.5 KHz Receiver Subcarrier Data ISO 14443-2 Type A: Modified Manchester ISO 14443-2 Type B: NRZ-L, BPSK ISO 18092 Typical Read Range 4-6 cm (1.5 to 2.
ViVOpay UniPay III UserManual 1.3 Installing ViVOpay UniPay III This section describes how to install the ViVOpay UniPay III on a mobile devices. devices Launch the transaction APP and get into the main payment screen Plug the UniPayIII into the audio jack of mobile device. The app will detect the model automatically, please select “UniPayIII”, and then see the UniPayIII connected indicator.
ViVOpay UniPay III UserManual Select “Start Contactless or MSR Transaction” Enter the total amount of the transaction then press “Start Transaction” or “Cancel”.
ViVOpay UniPay III UserManual Tap the card on UniPayIII, if reading card success, all four LEDs will blink once with one long beep; if reading card ca failure, only two short beeps be sounded. Host can select approved, declined or unreachable to complete the transaction. If Host accept the transaction, the receipt will be displayed, if the device connect to a print, the receipt will be printed to customer.
ViVOpay UniPay III UserManual 2 Firmware Upgrade The UniPay III can be upgraded using either the serial or USB interfaces. 2.1 Preparation To update the new firmware you will need: • PC with available serial or USB port • UniPay III unit • USB to Micro USB B type cable • UniPay III firmware update tool • Firmware file for the desired firmware 2.2 Procedure 1. Copy the UniPay III update tool and firmware on the PC. 2. Plug in the micro-USB B type cable to UniPay III, connect the USB cable to PC USB port.
ViVOpay UniPay III UserManual 7. Display “100% done” and device will reset.
ViVOpay UniPay III UserManual 3 ViVOpay UniPay III Troubleshooting The ViVOpay UniPay III is reliable and easy to troubleshoot. Symptom Possible Cause Remedy • ViVOpay UniPay III no power. Check battery status. • Ensure power level is correct. • Charging the battery via USB cable General Issues ViVOpay UniPay III does not appear to be powered on (no LEDs light).
ViVOpay UniPay III UserManual 4 Glossary Electronic Cash Register (ECR) The combination of a traditional cash register and a POS terminal, often PC-based. ExpressPay from American Express American Express contactless payment product that utilizes contactless technology. Firmware Software that is embedded in a hardware device that allows reading and executing the software, but does not allow modification, e.g., writing or deleting data by an end user.
ViVOpay UniPay III UserManual Point of Sale (POS) Refers to terminals used in retail stores with a magnetic stripe reader, keyboard, display and auto dialer modem or IP connection, connected to the telephone/internet network and used for on-line credit/debit authorization. Can also be connected to a host computer, which handles all transaction processing including item price look-up, data collection, and credit/debit authorization.
ViVOpay UniPay III UserManual 5 Customer Support Contact your local support representative for all support questions.