FCC ID:WQJ-IDCA-12X1 Operation Guidelines Xpress CM200 1
1. Scope This document describes the operation guidelines of xpress reader for EMC test. This document answered four questions as below shows. 1) How to install Xpress Reder. 2) How to use Xpress Reader for EMC test How to install Xpress Reader please install the reader as these steps: 1. Plug Cable Connector to PC. Like picture 1A show. 2.
. Plug Power connector (C) to RS232 Cable power connector(e), 3
. Plug the AC-Adapter nto AC100~240V ,then Xpress reader can work.
2. How to use Xpress Reader After power on Xpress Reader and reader was connect with PC, then user could read any Paypass Magstripe card or Visa MSD Card. The operate steps: Now the Card in box is demo card which can be used for test. 1. opern the PayPass Reader 10.4.
2.click the “Carrier ON ”,then the demo card can be tested.Put the card on Xpress reader.
FCC ID: WQJ-IDCA-12X1 FCC Compliance and Advisory Statement This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, according to Part 15 of the FCC rules.