Home Security Camera iCamera-1000 User Guide
Table of Contents CHAPTER 1 INTRODUCTION ............................................................................................. 1 Package Contents .............................................................................................................. 1 Features .............................................................................................................................. 1 LEDs ......................................................................................................
Chapter 1 Introduction 1 This Chapter provides an overview of the iCamera's features and capabilities. Congratulations on the purchase of your new iCamera. The iCamera is a Day and Night Network Camera with VGA resolution and 802.11n WiFi connectivity. Package Contents The following items should be included: • The iCamera Unit • Bracket * 1 • Y-Cable * 1 with boot • Adapter * 1 If any of the above items are damaged or missing, please contact your dealer immediately.
LEDs Front-mounted LEDs The iCamera has 3 LEDs. POWER/WiFi (Green) Network (Green) WPS (Green) • On (Green)- Power On • Off - Power Off • Blinking - Data is being transmitted or received. • Blinking Low - Weak strength of WiFi signal (1/2 Hz, SNR < 15 dB) • Blinking Medium - Strength of WiFi signal is normal (1/2 Hz, SNR < 15 dB) • Blinking High - Good strength of WiFi signal (1/2 Hz, SNR < 15 dB) • On (Green)- LAN/Wireless connection established.
Rear Panel LAN Port Use standard LAN cable (RJ45 connectors) to connect your PC to the port. PoE (Power over Ethernet) function is supported. Reset This button has two (2) functions: • Reboot. When pressed and released, the iCamera will reboot (restart). • Clear All Data. This button can also be used to clear ALL data and restore ALL settings to the factory default values. To Clear All Data and restore the factory default values: 1. Power On. 2. Keep holding the Reset Button down for 8 seconds.
Chapter 2 Initial Installation 2 This Chapter covers the software installation of the iCamera. Requirements • Network cable. Use standard 10/100BaseT network (UTP) cable with RJ45 connector. Procedure 1. Choose an Installation Site Select a suitable place to install the iCamera. 2. Disassemble the Mount kit Disassemble the mount kit in order to connect the LAN cable. 1. Take out the wall-mount kit from package box. 2. Remove Knob. 3.
Initial Installation 4. Power Up Connect the supplied power adapter to the iCamera. Use only the power adapter provided. Using a different one may cause hardware damage. 5. Check the LEDs • The POWER LED should be ON. • The Network LED should be ON (provided the PC is also ON.
Chapter 3 Specifications 3 This Chapter provides specifications for the iCamera. Specifications Model iCamera Dimensions 72mm (W) x 72mm (H) x 20mm (D) (without bracket) Operating Temperature Outdoor: -20° C to 45° C Indoor: 0° C to 45° C Video compression H.
Day/Night Mode Night mode Day mode SerComm P/N# 61930010LA SerComm P/N# 61930020LA Vendor P/N# Vendor P/N# 9347A3B, 9347A1B 7
Regulatory Approvals FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
