Icontrol One Link CH-1000 User Guide i
Table of Contents CHAPTER 1 INTRODUCTION ......................................................................................... 1 Package Contents.......................................................................................................... 1 Features......................................................................................................................... 1 LEDs .....................................................................................................................
Chapter 1 Introduction This Chapter provides an overview of the Icontrol One Link's features and capabilities. 1 Congratulations on the purchase of your new Icontrol One Link. This device is a primary controller and gateway, which includes Wi-Fi and Z-Wave home automation radios, providing connectivity to security systems and devices (including cameras and sensors).
LEDs Top-mounted LEDs The Icontrol One Link has four LEDs. Service Wi-Fi Z-Wave POWER • On (Green) - The CPE device is activated in iControl network. • Off - The CPE device is not activated in iControl network. • Flashing - The CPE device can not communicated with iControl network. • On - Wi-Fi device attached. • Off - Wi-Fi connection is not available or no Wi-Fi device attached. • Flashing - WPS function is activated. • On (Green) - Z-Wave devices attached.
Rear/Side Panel WPS Button Use a clip to press the WPS button on the device and on your other wireless device to perform WPS function that easily creates an encryption-secured wireless connection automatically. RESET This button has two (2) functions: • Reboot. When pressed and released, the Icontrol One Link will reboot (restart). • Clear All Data. This button can also be used to clear ALL data and restore ALL settings to the factory default values.
Chapter 2 Initial Installation This Chapter covers the installation of the Icontrol One Link. 2 Requirements • Use a standard 10/100BaseT network (UTP) cable with RJ45 connector. Procedure 1. Choose an Installation Site Select a suitable place to install the Icontrol One Link. 2. Connect LAN Cable Use standard LAN cable to connect the router and the Ethernet port on the Icontrol One Link. 4. Power Up Plug the Icontrol One Link into an outlet or extension cord. 5.
Appendix A Specification A Icontrol One Link Model CH-1000 Dimensions 97mm(W) * 60mm(D) * 40mm(H) (without plug) Operating Temperature 0° C to 40° C Storage Temperature -20° C to 70° C Network Protocol TCP/IP Network Interface 1 * 10/100BaseT (RJ45) WAN Port LEDs 4 LAN LEDs 2 Antenna 2 * Wi-Fi Internal Antennas 1 * Z-Wave Internal Antenna Power Adapter AC Input 120V with US Plug Regulatory Approvals FCC Statement This equipment generates, uses and can radiate radio frequency energy an
FCC Radiation Exposure Statement This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body. This device complies with Part 15 of the FCC Rules.