Installation Guide

ManualsBrandsiBEAM ManualsBack-Up & Dash CamerasLicense Plate Back-Up Camera - Black

iBEAMUSA.comiBEAM Vehicle Safety Sytems

REV. 04/24/2020 INSTTE-2MPTC

Attention!

When testing the aftermarket

equipment, ensure that all factory equip-

ment is connected before cycling the key to

ignition.

TE-2MPTC

INSTALLATION INSTRUCTIONS

#IBEAMSAFETY

Wiring ..................................................................2-3

Specifications .........................................................4

TABLE OF CONTENTS

TOOLS REQUIRED

• Wire stripper

• Tape

• Digital Multi-meter

• Cutter

Universal Accessory Camera

With Multi-mounts and Active Parking Lines

Visit iBEAMUSA.com for more detailed informatuon about the product and up-to-date vehicle specific

applications.

Product Features

• Multiple mounts included - license plate and surface mount

• Improved power circuit

• Can be viewed while driving with compartible monitor

• Water resistant - IP67

• Active parking lines

• 3 year warranty

Multi-Mounting Options

A) License plate mount B) Surface mount

A B

Part Components

• Camera

• License plate and surface mount

• Extension harness (27 FT)

• Screws

Summary of content (4 pages)

PAGE 1
TE-2MPTC INSTALLATION INSTRUCTIONS #IBEAMSAFETY Universal Accessory Camera With Multi-mounts and Active Parking Lines Visit iBEAMUSA.com for more detailed informatuon about the product and up-to-date vehicle specific applications. TABLE OF CONTENTS Wiring...................................................................2-3 Specifications..........................................................
PAGE 2
CAMERA WIRING Camera Wiring There are two options for powering up the camera.This camera can be powered to be available while the vehicle is running or to only be used as a back-up camera. Power camera with reverse 1. Remove the tail light from the vehicle to allow access to the light bulbs wiring. (If help is needed, review the vehicles owners manual section on replacing the tail light bulbs.) (Figure A) 2. Find the wiring that connects to the reverse bulb. There is normally 2 wires.
PAGE 3
CAMERA WIRING (CONT.) 1. Run the extension cable to the front of the vehicle. (Figure A) 2. The RED wire on the YELLOW RCA can be used in different ways. This wire is the same RED wire that is at the other end of the extension cable. (Figure B.1) • If connected to REVERSE in the rear, the RED wire at the YELLOW RCA can be used as a reverse trigger for a monitor, mirror or aftermarket radio. • If connected to 12 volt accessory in the rear, please cap off this wire on the YELLOW RCA.
PAGE 4
TE-2MPTC INSTALLATION INSTRUCTIONS #IBEAMSAFETY Sensor Effective Pixel Sync Frequency Resolution S/N Ratio Current Consumption Power Supply Operating Temp. Storage Temp. Viewing Angle (Dia.) Water Resistance Min. Illumination iBEAM Vehicle Safety Sytems ® CMOS II 736 X 592 NTSC 60 HZ 600 TV Lines More than 48dB No more than 280mW DC 12V +- 10% -22 ~ 176 F -40 ~ 176 F 170 IP67 0.5/F1.2 LUX iBEAMUSA.com Having difficulties? We’re here to help.