i3ALLSYNC HDMI User Manual
Table of Contents Chapter 1: Product Introduction ................................................................................................................... 3 1-1 Package Contents...................................................................................................................... 3 1-2 Hardware Recommendation .................................................................................................... 3 1-3 Hardware Setup/Installation ........................................
Chapter 1: Product Introduction Thank you for purchasing i3ALLSYNC HDMI Tx. This section is going to introduce i3ALLSYNC HDMI Tx more details as below. 1-1 Package Contents 1. i3ALLSYNC HDMI Transmitter (Tx) 2. Manual 1-2 Hardware Recommendation 1. Device with HDMI out to Tx • Supports up to HDMI 1080p output 2. Display connect to Rx • Display device (TV / Projector and so on) must support HDMI input • Maximum Display resolution is up to 1080P.
1-3 Hardware Setup/Installation 1. Connect your device 2. Activate i3ALLSYNC Rx.
After few seconds, the Rx device is in standby mode and ready to do screen mirroring from your Tx device.
Chapter 2: Use i3ALLSYNC HDMI Tx to screen mirroring.
When using the i3ALLSYNC HDMI Tx at the first time, please select “Setting” from Rx device, then hold down the main button of Tx for 4 seconds.
Enter the password of your router select “paring”, then it’ll start to auto pairing. After this procedure, the auto paring will complete.
2-2 Pairing OK, Ready to use. After the pairing connection completed, Tx is ready to screen mirroring.
Chapter 3: Box Configuration ⚫ LED Status Color LED Action Standby Red Lights up constantly Connection failed Red Flash three seconds and stop three seconds ⚫ Waiting for pairing White Blink Pairing Green Blink Paired and Ready Green Lights up constantly Mirroring Blue Lights up constantly Error Red Blink Without HDMI source Yellow Lights up constantly FW update White Blink Button and Switch for Tx 10
Item Function Description Main Button Pairing / Start mirroring / stop mirroring F1 Button Snapshot in Presentation Mode / Video Mode Mode Switch Switch Presentation Mode / Video Mode 11
Chapter 4: Troubleshooting and FAQ ⚫ Tx connected power but didn't receive HDMI in data. Please check the HDMI in is unplugged or not. ⚫ Disconnected Please check the Tx HDMI connection and power cable connection.
⚫ What's video mode and presentation mode? Mode indication is shown before mirroring. Presentation mode is designed with lower latency. Video mode is designed with higher FPS and the video play is smooth.
⚫ What's supported resolution of Tx HDMI in? Interface Tx HDMI in resolution HDMI 480i/p, 576i/p, 720p50Hz/60Hz, 1080i50Hz/60Hz ,1080p50Hz/60Hz FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
