User's Manual

The
SafeCom Concept
Think of
Printing in a new way.
You no longer send your print job directly to a
specific printer, you send it to a print job database,
where it is stored for later retrieval.
You can pull your print jobs from the database to
SafeCom printer by sliding your
SafeCard
through the
SafeCom terminal at the printer.
Thus, it is up to you,
where you want to print out
when
you want to print out.
And nobody but you will see your print jobs.
i-data international a-s
Vadstrupvej 35-43
• 2880 Bagsvaerd • Denmark
Phone: [phone]
• Fax: [phone]
Visit us at www.i-data.com
About i-data
Founded in 1981 and based in a suburb of Copenhagen,
Denmark, the i-data international group is comprised of
two divisions. i-data Printing Systems is the market and
technology leader in the printing connectivity market,
and LASAT Networks is one of Europe’s leading vendors
of Internet connectivity products for small to medium-
sized enterprises. The combined company has an
installed base of several million units. The i-data
international group has approximately half the Fortune
500 as customers, as well as thousands of small to
medium-sized enterprises worldwide. The company's
products are available in more than 40 countries through
an extensive network of distributors and sales offices.
NOTE:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
Communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for
help.
CAUTION:
Changes or modifications not expressly approved by i-data could
void the user’s authority to operate this equipment according to
part 15 of the FCC rules.
CE conformance
This product has been developed and produced in accordance
with the EMC directive and the Low Voltage directive and
therefore carries the CE mark.
Company and product names mentioned in this guide are
trademarks or registered trademarks of their respective owners.
Installation Instructions
No. 10404-02