2.4GHz WLAN Module WFM60-SFP202 2.4GHz WLAN(IEEE 802.11b/g/n) Stand-alone Module www.inctech.co.kr www.inctech.co.kr www.inctech.co.kr www.inctech.co.kr www.inctech.co.kr www.inctech.co.kr AUG. 8. 2019 Rev.0.
TABLE OF CONTENTS 1. APPLICATION ................................................................................................................................................................... 3 2. QUALITY ........................................................................................................................................................................... 3 3. APPEARANCE AND CHARACTERISTICS .........................................................................................
WFM60-SFP202 Datasheet 1. Application This specification is applied to the 2.4GHz WLAN(IEEE 802.11b/g/n) Stand-Alone module of I&C TECHNOLOGY. 2. Quality Quality should meet each condition which is mentioned on this specification. However, items which are not mentioned on this specification should follow the inspection agreements and standards which are agreed with both companies. 3. Appearance and Characteristics 3.
WFM60-SFP202 Datasheet 7. Mechanical Dimension Dimension 35.5mm× 23.5mm × 10.9mm(Max.) Figure1, 2 and 3 show the Top, Bottom and Side View of WFM60-SFPC202 package outline. Figure 1. Package Outline(Top View) Figure 2. Package Outline(Side View) Figure 3. Package Outline(Bottom View) 4 IEEE 802.
WFM60-SFP202 Datasheet 8. I/O Connector Pin Assign 1. 2. 3. 4. 5. RSTN VCC_5.0V GND TX RX Figure 4. Top View Figure 5. Bottom View ITEM SMW200-H05G (2.0mm Pitch Right Angle SMT Type Connector) PIN No. 1 2 3 4 5 PIN Name RSTN VCC_5.0V GND TX RX Function Description 5V level low active Reset Input Power Supply Input (5.0V) System Ground 5V level UART TXD 5V level UART RXD 9. General Description WFM60-SFP202 is a module for 2.4GHz WLAN(IEEE 802.11b/g/n). WFM60-SFP202 is available as 5 pin Module. (35.
WFM60-SFP202 Datasheet 11. Electrical Characteristics 11.1 Operating Condition Parameter Operating Temperature Supply Voltage VCC_5.0V Min. -30 4.5 Max. +85 6.0 Unit ℃ V 11.2 Tx Characteristics All measurements are made under nominal supply voltage and tested at External Antenna Port. (VCC_5.0V = 5.0V) and room temperature (25℃)condition. Parameters Conditions Min. 2400 Frequency Range Output Power (VCC_5.0V = 5.0V, spectral mask, EVM compliance) 802.
WFM60-SFP202 Datasheet 11.3 Rx Characteristics All measurements are made under nominal supply voltage and tested at External Antenna Port. (VCC_5.0V = 5.0V) and room temperature (25℃)condition. Parameters Conditions Min. 2400 Frequency Range 11b, Rx Sensitivity (8% PER for 1024 octet PSDU) 11g, Rx Sensitivity (10% PER for 1024 octet PSDU) 11n, Rx Sensitivity (10% PER for 4096 octet PSDU) Adjacent Channel Rejection CCK, 1 Mbps CCK, 2 Mbps CCK, 5.
WFM60-SFP202 Datasheet 12. Block Diagram Figure 6. Block Diagram 13. Revision History Ver. Comment 0.1 Initial release. 0.2 Modify module dimensions. Date May. 7, 2019 AUG. 8, 2019 Author M.H.LEE M.H.LEE Approver 8 IEEE 802.
WFM60-SFP2 P202 Datasheet 14. FCC/IC Statement FCC Part 15.19 Statements: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
requirements of FCC rule 15.203 and 2.1043 as permissive change procedure. The use of a different trace layout other than approved requires a Class II Permissive Change or a New Grant as appropriate. End Product Labeling Information on test modes and additional testing requirements Additional testing, Part 15 Subpart B disclaimer The module is labeled with its own FCC ID.
