EMC STB-100H DIGITAL CABLE RECEIVER USER'S MANUAL
CONTENTS 1. Notice 2 2. Safety/Precautions 2.1. Safety 2.2. Precautions 2 3. Menu Map 3 4. Front Panel 4 5. Rear Panel 5 6. Operation 6 7. Specifications 7 Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Safety/Precautions 1.1 Notice * Theft of service is a crime. * Installing this device without permission or unauthorized tampering, modifying or altering it in any way may subject you to civil or criminal penalties. WARNING : To prevent electric shock, DO NOT REMOVE COVER. No user serviceable parts inside. 2.1 Safty * Be sure to read the user's manual before starting the operation of the unit. * Do not touch the power cord with wet hands as it may cause electric shock. * Never open the cover.
Menu Map 3.
Front panel 4. Front Panel 3 1 2 4 7 8 5 6 9 1. Standby/Power on Indication light : Turn on red light while in “ standby mode”and turn off red light while in “ power on mode” . 2. Remote Control Indication light : Flashes green when receiving data from Remote Control Unit. 3. Power : To switch the receiver in "standby mode”or in “ power on mode” . 4. Remote Sensor : Receives the infrared signal from Remote Control Unit. 5. To launch or terminate the menu application. 6.
REAR PANEL VIEW 4. REAR PANEL VIEW 3 1 No 1 2 3 4 5 6 7 8 9 2 Name TV OUT(Ch 3/4) CABLE INPUT CVBS S/PDIF AUDIO L AUDIO R S-VIDEO MODEM AC INPUT 4 6 5 7 8 9 Connector Function IEC 169-24, femaleRF re-modulation output. IEC 169-24, femaleCable signal input to Digital tuner. RCA cinch Composite video output. RCA cinch Digital Audio output. RCA cinch X2 Left audio output. RCA cinch X2 Right audio output.
REMOTE CONTROL UNIT 5. Remote Control Unit 1. POWER : To switch into ‘ standby’or power on’mode. 2. Homepage : Moving to selected homepage 1. Power 2. Home 3. TV : Show the TV channel 3. TV 4. Music : Show the music channel 4. Music 5. PPV 5. PPV 7. Exit 6. Back:To return previous channel. 6. Back 7. Exit:To return to previous status or menu 8. Volum 9. Channel 8. Volum:To adjust the volume level. 9. Channel:To change channel. 10. Mute 11. Program 12. Laguage 13. Menu 14. subtitle 15.
Operation 6. Channel scanning - Press number key"007911" in above main menu - After entering "scan network" menu, set up below values according to network set up. * Frequency: Using number key in RCU * Symbol rate: Using number key in RCU * Modulation: Using right/left key in RCU - After finishing network set up, press OK key in order to signal locking. - After checking Level and Quality, press exit key.
Specifications 7. Specifications System capabilities Tuner input & Video Decoder MPEG Audio Remote control Power supply Fully DVB-C(QAM) system Connector IEC 169-24, female Input Frequency range 47~862Mhz Signal level -15 ~ +15 dBmV Input Impedance 75 ohm Modulation Format 64, 128, 256 QAM FEC Annex A & C Front end CABLE Symbol rate 4 ~ 5.