P/N : M1000-031118 User Manual www.mobiblu.
Safety Warnings and Cautions Please be aware of these safety instructions and use the product properly in order to prevent risks of injury or damages. Avoid exposing the product to direct sunlight (High temperatures applied to the product may cause damage.) Avoid dropping or causing impact the product. (It may cause serious damage to the product.) Avoid placing the product under high moisture or dust level (It cause damage to the product.
Safety Warnings and Cautions Special Features of the Product Polished Simple Design The World Best Multi-Codec Player Do not use any chemical or detergent for cleaning the products as it may discolour or strip the product surface. Keep the product away from areas where extreme vibrations or magnets exist. Quality enhancements have been made including an upgraded Graphic LCD with Negative Graphic display. Mass Storage: You don’t need the software CD anymore.
Contents My Multiformat Digital Audio Player What is a Digital Audio Player? Product Specifications PC System Requirements and Accessories Hardware Descriptions About Power Supply Software Installation Connecting the Player to a PC using a USB Cable Separating the USB cable from the Player File Download/Upload OS Update & Format LCD DISPLAY Illustration Power On /OFF Music Listening Volume Control Music Selection HOLD (Lock Function) MODE Changing Voice Recording FM RADIO MODE Searching FM Frequencies Stori
What is a Digital Audio Player? Product Specifications What is a MP3 file? MP3 stands for MPEG1-Layer3 and it uses a compression technology that converts conventional CD music data into an MP3 file format that is used on a PC, at 1/12 compression ratio. It provides near CD-quality music at 128kbps.
PC System Requirements and Accessories Hardware Descriptions PC System Requirements and Accessories Front Side Connection Port for Earphones PC system requirements for the product are as follows: Microsoft OS (Windows 98, ME, 2000, XP) CD-ROM Drive Pentium 200MHz or higher CPU 32MB (64MB for Windows ME or 2000) or higher RAM Available hard disk space of more than 128 MB (Additional hard disk space is required for storing music files) USB port available (Rear port highly recommended) Volume Up/Down LED
About Power Supply About Power Supply Using cylindrical AAA type batteries Open the battery case cover on the back by pushing the tip in the direction of arrow using a finger / fingernail. Insert an AAA battery with correct polarity positions as shown in the picture Battery Power Indicator At its initial start-up, the remaining battery indicator may fluctuate. After 5 or 6 seconds, the display will show the actual reading.
Software Installation Please Note! Software Installation the installation in accordance with the 2 Continue following diagrams. With the special feature of Mass Storage system, the product is able to upload and download the files without installing any software in the PC. - For Windows 98SE: The software should be installed before using the product. (Can not be recognized in the PC) - For Windows ME, 2000, XP: The software only needs to be installed when you try to update the product OS.
Software Installation 3 Verify if the Menu “Start Program HYUNWON DAH-1300 MP3 Player” has been created as in the following diagram. Connecting the Player to a PC using a USB Cable one end of the ‘supplied’ USB cable to one of 1 Connect the USB ports on the back of the PC, and connect the other end to the player.
Disconnecting the USB cable from the Player disconnecting the USB cable from the PC, 1 Before double click on the green arrow icon on the toolbar Disconnecting the USB cable from the Player the dialogue box “Safe Removal of the Hardware” 3 When appears, click on the [OK] button to remove the USB Cable. located at the bottom right of the screen.
File Download/Upload File Download/Upload select the device as your new directory and then 2 Now using the right button of the mouse click on the ‘Paste’ to Please Note! As well as playing music, you may also use the product to upload/download any other data files (*.jpg, *.xls, *.doc,….) to/from the PC as a portable disk. paste the file(s) to the portable disk as depicted below.
File Download/Upload 3 File copy has now been completed as shown below. OS Update & Format Please Note! Install the program on the PC before updating the OS. (See page 8) 1 Download the OS for the player from the CD to the PC. Recovery Mode The system will enter into the Recovery Mode 5 seconds after connecting the USB cable to the player while pressing and holding the Play button on the player.
OS Update & Format Please Note! What is OS? OS is an internal operating system to drive the product. OS Update & Format on “Start” button from the OS update window 3 Click which appears about 10 seconds later to complete the OS Update and “Close”. on “Start Program HYUNWON DAH-1300 2 Click MP3 Player Update” subsequently. Check in the blank when only formatting. 4 Click! Click! Click! Click! Click! Click! The OS Update has been completed. Now use the product by turning the power on.
OS Update & Format LCD DISPLAY Illustration MUSIC MODE About the Format b c a d e f g a. Displays music titles and the sequence Take care before formatting the product, ALL files will be deleted. Format with OS Update Refer to OS Update on page 18~19. h 1 Check in the blank of “Format Data j k i l m FM MODE b a Area” b. Displays the current music status (Play Pause Stop ) c. Displays the current play time of the music d. Displays the file format e. Displays the total number of tracks f.
Power On /OFF Music Listening MUSIC MODE 1 1 Power on Push the Play button( Music Playing Press the play button( ) to play the music at Stop or Pause status. ) to turn on the power an intro screen will be displayed. Note! Providing there is remaining battery life. 2 Power off Power off: Press and hold the Play button( power. 2 ) for 5 second to turn off the The blue LED on the product flashes when either music or voice files are playing. - It also blinks during LED Time setting.
Volume Control 1 Music Selection 1 Volume Up By pressing the ( ) button briefly it increases the volume by one step, while pressing the button for a longer period increases the volume continuously until maximum is achieved or pressure is released. By briefly pressing the FF button : The next song will be selected in Play or Stop mode.
Music Selection HOLD (Lock Function) 3 By briefly pressing the REW button : In Stop Mode In Play Mode The previous song will be selected. The current song will be replayed from the first. HOLD (Lock) is set with a padlock icon displaying for 3second on the LCD when you push the HOLD switch on the back of the product as shown below figure. 4 By continuously pressing the REW button : Once in the HOLD mode, no button will be recognized displaying HOLD Icon on the LCD.
MODE Changing 1 2 Voice Recording Push and hold the MODE button. Please Note About the recording.... Press the MENU button after moving to desired MODE using FF/REW button. The voice recording starts when you push and hold the REC/ A-B button. To record from the FM radio… Record the sound source in the FM Mode. MUSIC MODE To record Voice… Record the voice source in the Music or Voice Mode. VOICE MODE An orange colored LED flashes during the voice recording. It also blinks at LED time setting.
Voice Recording Voice Recording pressing the Play 3 By button again the saved file voice recording starts 1 The when you push and hold the REC/ A-B button. starts can be played back. Displaying time elapsed for recording Remaining recording time in the memory The functions for Play/Stop/Volume Control/ FF, REW are the same as in the MUSIC Playing MODE. stop the recording press 2 To the Play button. The files are saved in the following sequence V001, V002, V003….
Voice Recording FM RADIO MODE 1 Push and hold the MODE button. Please Note! You can only listen to the saved file after entering Voice Recording Mode. (The voice file can not be played back in the Music Playing MODE) After recording the voice file will be saved as a ADPCM file with the extension of ADP at the end of the file name. The volume is automatically adjusted in the recording. Note! The earphone takes the roll of radio antenna.
Searching FM Frequencies Set the FM frequencies using the FF/REW button. Storing the Selected Frequency Storing the searched frequency manually the FF/REW button you can store the searched 1 Using frequency after entering to FM Preset MODE by pressing the MENU button briefly after selecting the “Manual Preset”. Searching Frequencies Manually You can search frequencies by pushing the FF/REW button briefly. (Increment or decrement by 0.
Storing the Selected Frequency 3 Press and hold the MENU button to save the frequency after selecting one using the FF/REW button. Storing the Selected Frequency the MENU button once again briefly after 2 Press selecting “Auto Preset” from the FM Preset MODE using the FF/REW button. Note! - You may store multiple frequencies with the above method. - Up to 20 frequencies may be stored in the product.
MENU Setting MENU Setting MENU Searching Please Note! To select and save the Menu Note! - MENU Selection: Press the MENU button briefly after selecting the desired option using FF/REW button. Entering the MENU Mode. - Press the MENU button from the Voice Recording or Music Playing Mode to enter the MENU Screen. - Storing Menu Setting: Press the MENU button for a longer period after setting the Menu. - Menu Cancellation: Press “REC/A-B” button to go back to the previous menu.
MENU Setting Intro Play Time When listening to only the intro parts of all the tracks stored, one of 2”/4”/6”/8”/10” can be selected. (Verify it after setting the intro from the Play Mode.) * See page 26 MENU Setting Display Select “Display” from the MENU Mode. Contrast The brightness of the screen can be set in Contrast, within the range of 1 to 11. Recording MODE When performing Voice/Radio Recording, one of 32/44/64/88/128/192 kbps can be selected as the recording Bit Rate.
MENU Setting MENU Setting LED Time The function enables to set the duration of LED flashes (Disable 10sec. Always) when using the product. Disable: LED off 5sec. Always: LED flashes continuously Timer Select “Time” from the MENU Mode. Automatic power save mode It is possible to select the automatic power save time for non usage (Disable/1 min/2 min/3 min/10 min) in Pause/Stop status. - Disable: The power will not turn off automatically.
MENU Setting MENU Setting Play Mode Select EQ Select “Play Mode” from the MENU Mode Select “Select EQ”from the MENU Mode Play Mode This mode enables you to set ‘the playback function to one of the following “NORMAL -> INTRO -> REPEAT 1 -> REPEAT-ALL -> RANDOM 1 -> RANDOM-ALL”.
MENU Setting MENU Setting Erase About (Specification of the product) Select “Erase” from the MENU Mode. Erase Select “About” from the MENU Mode This function allows the deletion of files from the product without it being connected to PC. About This function enables you to display the OS version, full memory capacity and the remaining capacity of the product. 1) A warning message “Are you sure you want to delete this file?” shows on the LCD screen. 2) Choose “Yes” or “NO” using the FF/REW button.
Setting for Ranged Repeat How to select a folder REPEAT A-B MODE (playing a particular section of the current music repeatedly) How to select a folder. the REC/A-B button once briefly while music is 1 Press being played. enter FOLDER NAVIGATION 1 To mode, press MENU button “DOUBLE TIMES” during PAUSE/STOP/PLAY mode. The display shows ‘ ’ 3 seconds or longer, press the REC/A-B button 2 After once again briefly. The Display shows ‘ ’ and the player repeats the ‘A-B’ section.
How to select a folder 2 Select the folder you want by moving FF/REW key up or down. Then, press the PLAY/PAUSE Key to select the folder. It May Not be a Trouble! Case Does not respond to the buttons being pressed The digital audio player malfunctions if there’s no folder displaying, please go to step 3.
Warranty Services Customers are entitled to warranty service for a period of one year from the date of purchase. Warranty service does not apply to defects resulting from customer fault or acts of God. Non-warranty service shall apply to defects resulting from : 1. Infiltration of foreign matter, such as water, liquid, or sand. 2. Breakage due to dropping or severe impact. 3. Damage to or deformation of the outer case caused by organic solvents, such as benzene. 4.
WARRANTY FORM Warranty Term: 1 year from the date of purchase Product Model : Date of Purchase : Name of purchaser : Address : Place Purchased : Address : (month) (day) Phone Number : (year) Phone Number : Hyunwon Incorporated You need to show this Warranty Certificate with the date of purchase when requesting service, in order to receive satisfactory services. Please keep the Warranty Certificate in a safe place. 1.