Specification Sheet

DESCRIPTION
Document No. 4808583A 02/14/18 Page 1
SPECIFICATIONS
*Power will vary depending on the SDRAM used.
HX429C17FWK4/64
64GB (16GB 2G x 64-Bit x 4 pcs.)
DDR4-2933 CL17 288-Pin DIMM Kit
Continued >>
kingston.com/hyperx
FEATURES
HyperX HX429C17FWK4/64 is a kit of four 2G x 64-bit (16GB)
DDR4-2933 CL17 SDRAM (Synchronous DRAM) 2Rx8, memory
module, based on sixteen 1G x 8-bit FBGA components per module.
Each module kit supports Intel® Extreme Memory Profiles
(Intel® XMP) 2.0.
Total kit capacity is 64GB. Each module has
been tested to run at DDR4-2933 at a low latency timing of 17-19-19
at 1.2V.
Additional timing parameters are shown in the
Plug-N-Play (PnP) Timing Parameters section below. The
JEDEC standard electrical and mechanical specifications are
as follows:
CL(IDD)
Row Cycle Time (tRCmin)
Refresh to Active/Refresh
Command Time (tRFCmin)
Row Active Time (tRASmin)
Maximum Operating Power
UL Rating
Operating Temperature
Storage Temperature
17 cycles
45.75ns(min.)
350ns(min.)
26.55ns(min.)
TBD W*
94 V - 0
0
o
C to +85
o
C
-55
o
C to +100
o
C
JEDEC/XMP TIMING PARAMETERS
• JEDEC/PnP: DDR4-2933 CL17-19-19 @1.2V
•XMP Profile #1: DDR4-2933 CL17-19-19 @1.2V
•XMP Profile #2: DDR4-2666 CL16-18-18 @1.2V
• Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP = 2.5V Typical
• VDDSPD = 2.2V to 3.6V
• On-Die termination (ODT)
• 16 internal banks; 4 groups of 4 banks each
• Bi-Directional Differential Data Strobe
• 8 bit pre-fetch
• Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop)
• Height 1.340” (34.04mm), w/heatsink
Note: The PnP feature offers a range of speed and timing options to support
the widest variety of processors and chipsets. Your maximum speed will
be determined by your BIOS.
HX429C17FWK4/6
4
6
4
G
B
(
16
G
B 2
G
x 64-Bit x 4 pcs.
)
DDR4 2933 CL17 288 Pin DIMM Kit
Memory Module Specifications