User's Manual

ManualsBrandsHYDX ManualsElectronicsTwo Way Radio

User’s

manual

Radio Mini

Basic Introduction

Parts list

Radio *1 Li-ion Battery Pack*1 User’s Manual*1 Belt Clip*1 Hand-Strap*1

Adaptor *1 USB cable*1

Basic parameters:

Size: 130*52*14 Weight: 80g Operating Voltage:3.3-4.2v DC Channels: 16

Working Temperature: -10℃--+40℃

1. PTT 2 light 3. Mic 4.Speaker 5. Antenna 6. Side key PTT 7.Channel + 8.Channel -

9. Power on /off Switch 10. Volume Switch 11. Microphone Interface 12. Earphone Inte

rface 13. USB Interface 14. Battery

Status of Indicator light

1- Indicator

Green light flashes when radio is receiving. Red light flashes when radio is

transmitting.

2-Channel Switch

Choosing desired channel to communication from 1-16. When the UP button is

pressed, the channel rises.When the DOWN button is pressed, the channel drops

and the channel loops.

3-Power Switch

Press the power switch key about 2 seconds to turn on the radio. When the

radio needs to turn off, press the power switch key about 2 seconds to turn off.

4-PTT

The radio has two PTT switches on the side and the front.Press PPT and face to

microphone to communicate with the others. Red light flashes. Release PTT to receive

and the green light flashes.

5-Monitor

F10,F18

Summary of content (6 pages)

PAGE 1
F10,F18 User’s manual Radio Mini Basic Introduction Parts list Radio *1 Li-ion Battery Pack*1 Adaptor *1 USB cable*1 User’s Manual*1 Belt Clip*1 Hand-Strap*1 Basic parameters: Size: 130*52*14 Weight: 80g Operating Voltage:3.3-4.2v DC Channels: 16 Working Temperature: -10℃--+40℃ 1. PTT 2 light 3. Mic 4.Speaker 5. Antenna 6. Side key PTT 7.Channel + 8.Channel 9. Power on /off Switch 10. Volume Switch 11. Microphone Interface 12. Earphone Inte rface 13. USB Interface 14.
PAGE 2
Long press channel UP key can turn on the receiving and monitor function for a long time , and then press it to turn off the monitor function. 6-Squelch level The purpose of the squelch is to mute the speaker when no signals are present Lower squelch level ,high background noise hear ,longer communication range ,weaker the anti-inference . Level 0 is to open the squelch .
PAGE 3
14-Charging Indicator The charger is charged by Android data line. When charging, the indicator light is red. 15-Channel Locking Function Long press the channel DOWN key to hear the “beep” twice, then the channel is locked in the currently set channel. Long press the channel” DOWN” key to unlock the channel after hearing the sound of “di,” and the channel switch can operate normally. Troubleshooting Problem solution No power The battery maybe run out please renew it or recharge it.
PAGE 4
Warranty Card Contact ：__________________________ Company Name___________________________________ ADD：_________________Post Code：_________________________ Tel：__________________Mob.： ____________________________ Fax：_______________ Email: ______________________________ Ordered ：______________Model：_____________________________ Ordered No.：___________Purchased Date：_____________________ (S/N）： __________________ (EAN）：____________________________ Warranty Card No.
PAGE 5
FCC Warning Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device. RF Exposure complianceStatement and operating instructions The device has been tested against the SAR limit (1.6W/kg). The highest SAR value reported under this standard during product certification for use at the Face up is 0.185W/kg and when properly worn on the body is 0.
PAGE 6
ISEDC WARNING: This EUT is compliance with SAR for controlled exposure limits in IC RSS-102 and had been tested in accordance with the measurement methods and procedures specified in IEEE 1528 and IEC 62209. This equipment should be installed and operated with a minimum distance of 2.5cm must be maintained when held-to-face, and body-worn operations are restricted to the approve doriginal acessories.