User's Guide

ManualsBrandsHWM-Water ManualsElectronicsEchoChirp AMR Transmitter

485‐027‐V2

485‐033‐V2

FCCID:RUZ‐485

EcochirpAnalogueTransmier

485‐027‐V2

485‐033‐V2



FCCID:RUZ‐485

Part number : MAN-485-0025-B









Iffurthersupportorassistanceisrequired,pleasecontactFCS

TechnicalSupporton1‐800‐531‐5465

ore‐mailsales@ﬂuidconservaon.com

WARNING:‐LITHIUMBATTERIES

Ifbaeriesareexposed‐donotshortcircuit,re‐charge,puncture,incinerate,crush,immerse,force

dischargeorexposetotemperaturesabovethedeclaredoperangtemperaturerangeoftheproduct.

Riskofﬁreorexplosion.Thesebaeriesaresealedunitswhicharenothazardouswhenusedaccording

therecommendaonsofthemanufacturer.

2. CONNECTIONS

Itisrecommendedwhenconnecngtoasensoroutputchannel1connectedtheredwire

(posive)andtheblackwiretothecommon(negave).



DualchannelanaloguetransmierswillbelabelledCh1&Ch2withredandblackwiresfor

channel1.Forchannel2,Blue

isusedfornegaveandyellowforposive.



SingleChannelAnalogueTx

DualChannelAnalogueTx

Red–AnalogueCh1+ve Red–AnalogueCh1+ve

Black–AnalogueCh1–ve Black–AnalogueCh1–ve

Yellow–NoFuncon Yellow–AnalogueCh2+ve

Blue–NoFuncon Blue–AnalogueCh2–ve



1.EcochirpAnalogueTransmierQuickStartGuide

Thisguidecoversonlythemostbasicoperaonsincludingconneconsandcommissioning.



INTRODUCTION

TheAnaloguetransmierisalowcost, easytoinstall, durable transmierusedtotransmit

theoutputstateofanysensorwitha0‐10Vvoltageoutput.Themarketleadingtransmieris

designedtoprovidereal‐memonitoringinformaon.Thereareaseleconofvariaons

e.g.

singleanddualinputsavailable.



Summary of content (2 pages)

PAGE 1
. Ecochirp Analogue Transmi er Quick Start Guide This guide covers only the most basic opera ons including connec ons and commissioning. INTRODUCTION The Analogue transmi er is a low cost, easy to install, durable transmi er used to transmit the output state of any sensor with a 0‐10V voltage output. The market leading transmi er is designed to provide real‐ me monitoring informa on. There are a selec on of varia ons e.g. single and dual inputs available.
PAGE 2
3. INSTALLATION The op mum opera ng temperature is between –10°C and +40°C. We cannot guarantee the maximum life; therefore it is recommended to keep within the op mum opera on temperature range for maximum ba ery performance. Opera ng in extreme environmental condi ons will degrade the life‐ me of the ba ery. 5. COMMISSIONING The transmi er ID/serial number should be noted along with the corresponding connected equipment reference.