Quick Start Guide

MAN-154-0002-A Page 1
Patroller 4
Quick Start Guide / Safety Information
Guía Rápida / Información de Seguridad
Guide de démarrage rapide / Information
de sécurité
This document applies to the following family of devices:
/ Este document afecta a los siguientes dispositivos:
/ Ce document s’applique à la famille de produit :
• PAT4 / * / * / *
Introduction:
This guide covers most basic operations including
connections and commissioning.
For more details, refer to www.hwmglobal.com
The Patroller 4 is an interface that is required for
setup and configuration of various HWM devices.
Please refer to your main product guide for more
details.
Contents:
Patroller 4, USB cable, antenna (various options), car
adaptor (optional), mains adaptor (optional).
Installation Instructions:
1. Attach antenna. Check safety section for antenna
position and tightening guidelines. For maximum
transmission range the antenna should point
upward (vertical polarization) and should be kept
clear of obstructions, particularly metallic
surfaces.
2. Do not expose the Patroller 4 to moisture.
Use Instructions:
Switch unit on/off:
1. Turn unit “ON”: Press button. Red LED indicates
unit off. Hold button for 2 seconds until green.
2. Turn unit “OFF”: Press button. Green LED
indicates unit on. Hold button for 2 seconds until
red.
3. Short press indicates status. Red = off, Green =
ON.
4. Unit will automatically power off if not used for 30
minutes.
Connecting to HWM application:
5. If using PC application, connect to PC via USB
cable.
6. If using a mobile phone app, connect with the
phone using Bluetooth by following the
instructions in the app guide.
Battery operation – LED meaning:
7. LED flashes red every 5 seconds: No devices
detected.
8. LED flashes green when compatible HWM devices
are in radio range and transmit a message.
9. LED flash is green when the battery is OK. LED
flash is red when the battery is low; Charge the
unit.
Charging operation – LED meaning:
10. LED flashes red twice, every 5 seconds: Battery
very low. Radio functions disabled.
11. LED red: Charging.
LED green: Charging complete.
LED flashes when compatible HWM devices are
in radio range and transmit a message.
Unit always functions when powered by cable,
except (see 10).
Charging Instructions:
1. Connect USB cable between the unit and a
powered USB connector (Car adaptor or mains
adaptor, etc).
2. LED displays red until fully charged, then green.
EN
ES
FR
EN
USB
Antenna
Antena
Antenne
LED
Button
Botón
Bouton