User's Manual

ManualsBrandsHUSQVARNA ManualsElectronicsMachine Distance Sensor

User Manual

PUBLIC

LP9505-UM-001 Rev A HUSQVARNA CONSTRUCTION - User Manual MDS System description-2 2020-02-10 1 (4)

HUSQVARNA CONSTRUCTION

MDS System

Description and

User Manual

Scope

This is a description of the label of the Husqvarna MDS Machine Distance Sensor.

Supplementary documents

Area - Title: HUSQVARNA CONSTRUCTION - MDS System – User Manual

Document ID:

LP9505-UM-001

Revision: A

Info Class: PUBLIC Date: 2020-02-10

Owner: EM-CEUC Approved:

Elin Kajsajuntti

Summary of content (4 pages)

PAGE 1
User Manual HUSQVARNA CONSTRUCTION MDS System Description and User Manual Scope This is a description of the label of the Husqvarna MDS Machine Distance Sensor.
PAGE 2
User Manual 1 Overview The MDS system is a radio based system for the measuring of distance from a user to a moving machine. The system consists of three devices, one MDS-anchor mounted inside a remote control unit and two MDS-tags placed within the front and rear of a machine. The MDS system enables the distance to be measured between both of the two MDStags in the machine and the MDS-anchor in the remote control unit. MDS is an acronym for Machine Distance Sensor.
PAGE 3
User Manual Control signals between the remote control unit and the machine are transmitted via a separate radio link based on ISM 2,4GHz radio technology. The MDS system is paired at the same time as the remote control radio modules are paired. All processing and validation of distance data from MDS system is done by ECU inside the moving machine. The MDS-anchor is mounted inside the remote control called MC11-OPS. It receives power from the remote control (either battery or control cable).
PAGE 4
User Manual 4 Regulatory information 4.1 FCC United States This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.