Illustrated Parts List 2008-01 I0807213 531 30 70-05 Sleeve Hitch (23 inch tire) (45-03021) Repair Parts Manual
™ OWNERS MANUAL Model No. 45-03021 SLEEVE HITCH CAUTION: Read Rules for Safe Operation and Instructions Carefully • • • • • Safety Assembly Operation Maintenance Parts the fastest way to purchase parts www.speedepart.com PRINTED IN USA FORM NO.
SAFETY RULES 6. Before lowering and operating the implement, be sure no one is near the area of operation. 7. Lower the sleeve hitch and implement when leaving vehicle unattended. 8. Vehicle braking and stability may be affected. Drive slowly when sleeve hitch and implement are in raised position. Stay off of steep slopes. 9. Keep all nuts and bolts tight and be sure the equipment is in safe operating condition. 1.
CARTON CONTENTS 1 4 2 IF YOUR TRACTOR LOOKS LIKE FIGURE 2A 2. Install two 3/8" x 1-1/4" hex bolts in the left side of the tractor as shown. Attach the left (L.H.) Mounting Bracket (pin at top facing in) to the bolts using two 3/8" lock washers and 3/8" hex nuts. Repeat on the right side. See figure 2A. 5 3 3/8" x 1-1/4" HEX BOLT 7 6 8 RIGHT MOUNTING BRACKET 1. 2. 3. 4. 5. 6. 7. 8. Sleeve Hitch Frame Assembly Mounting Bracket (R.H.) Mounting Bracket (L.H.
. Place the L.H. Pivot Bracket onto the end of the Lift Lever Assembly (the R.H. Pivot Bracket comes already installed on the assembly). See figure 3. 6. Attach the R.H. and L.H. Pivot Brackets to the Sleeve Hitch Frame Assembly using four 3/8" x 1" carriage bolts and 3/8" nylock nuts. See figure 3. 8. Assemble the two 5/8" jam nuts halfway onto the two 5/8" x 2" hex bolts. Screw the bolts into the nuts that are welded to the Sleeve Hitch Lift Assembly. Tighten the jam nuts against the welded nuts.
OPERATION 1. Move the lift lever backward to lower the sleeve hitch. 2. Attach an implement using the sleeve hitch pin. Tighten the 5/8" x 2" stabilizer bolts against the implement hitch and then tighten the jam nuts. See figure 5 on page 4. IMPORTANT: Some implements may require that the stabilizer bolts not be tightened. Refer to your implement owner's manual. 3. The sleeve hitch is assembled in the lowest position by the assembly instructions.
REPAIR PARTS FOR MODEL 45-03021 SLEEVE HITCH 26 20 27 16 24 21 25 3 19 18 17 4 7 1 12 11 8 15 A 11 23 15 9 14 2 10 5 12 A 13 22 13 11 Ref Part No.
NOTES 7
the fastest way to purchase parts www.speedepart.com © 2004 Agri-Fab, Inc REPAIR PARTS Agri-Fab, Inc. 809 South Hamilton Sullivan, IL. 61951 217-728-8388 www.agri-fab.
