Operator′s manual Manual d’utalisation Manual de instrucciones Hedge Trimmer Attachment HA110 HA850 Complément Taille-haie HA110 HA850 Tijeras cortasetos (suplemento) HA110 HA850 GB FR ES
KEY TO SYMBOLS Symbols WARNING! Incorrect or careless use of a hedge trimmer can turn it into a dangerous tool that can cause serious or even fatal injury. It is extremely important that you read and understand the contents of this operator’s manual. Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. Other symbols/decals on the machine refer to special certification requirements for certain markets.
CONTENTS Contents KEY TO SYMBOLS Symbols ....................................................................... CONTENTS Contents ...................................................................... Note the following before starting: ................................ WHAT IS WHAT? What is what on the hedge trimmer attachment? ........ SAFETY INSTRUCTIONS Machine′s safety equipment ........................................ ASSEMBLY Fitting the hand guard and loop handle (HA 110) .........
WHAT IS WHAT? 6 1 12 2 11 7 3 5 10 4 8 9 What is what on the hedge trimmer attachment? 1 Cutter 7 Hand guard (HA 110) 2 Grease nipple and plug for filling lubricant.
SAFETY INSTRUCTIONS Machine′s safety equipment This section describes the machine′s safety equipment, its purpose, and how checks and maintenance should be carried out to ensure that it operates correctly. See the ”What is what?” section to locate where this equipment is positioned on your machine. The life span of the machine can be reduced and the risk of accidents can increase if machine maintenance is not carried out correctly and if service and/or repairs are not carried out professionally.
ASSEMBLY Fitting the hand guard and loop handle Fitting the cutting head (HA 110) It is impor tant that the hedge trimmer is laid on a flat surface when you fit the cutting head. Otherwise the cutting head may not be fitted straight. 1 Loosen the clutch sleeve’s two mounting bolts and dismantle the clutch sleeve. 2 Assemble the hand guard and loop handle by screwing them together. Take care to align the holes in both parts. 1 Fit the cutting head to the shaft.
STARTING AND STOPPING Check before starting • Inspect the working area. Remove any objects that could be thrown out. • Check the cutting attachment. Never use blades that are dull, cracked or damaged. • Check that the machine is in perfect working order. Check that all nuts and screws are tight. • Make sure the gear housing is lubricated correctly. See instructions under the heading Gear housing. • Check that the cutting attachment always stops when the engine is idling.
WORKING TECHNIQUES General working instructions Safety instructions while working IMPORTANT! This section takes up the basic safety precautions for working with a hedge trimmer. • Always ensure you have a safe and stable working position. If you encounter a situation where you are uncertain how to proceed you should ask an expert. Contact your dealer or your service workshop. • Always use both hands to hold the machine. Hold the machine at the side of your body.
WORKING TECHNIQUES • Always wear heavy-duty gloves when repairing the cutting attachment. This is extremely sharp and can easily cause cuts. • Store the machine out of reach of children. • Use only original spare parts for repairs. 2 Press the cutting unit against the hedge or some other firm surface until the required angle is set. 3 Tighten the knob. Basic working techniques • Work with a swinging action from the bottom upwards when trimming sides.
MAINTENANCE Gear housing Maintenance schedule Below you will find some general maintenance instructions. If you need further information please contact your service workshop. There is a grease nipple and a plug for filling lubricant on the gear housing. Use a grease gun to fill with grease. New machines are first filled with grease after approximately 20 hours of operation, and subsequently approximately every 60 hours of operation. Use Husqvarna’s special grease, no. 503 98 96-01.
50040-20 ´®z+R$"¶0F¨ ´®z+R$"¶0F¨ 2005-07-07
