FR Manuel d'utUisation, pp. 23-44 EN Operator's de instrucciones, manual, pp, ES Manual pp. 45-66 2-22 I 2SEx_sERIES .
CONTENTS Contents Introduction ................... 2 .................. 3 Key to symbols Safety instructions Description ..................... Fuel handling Starting ............... and stopping Using the blower Maintenance Technical 11 ............ ................. .................... data 4 6 .................... 12 13 18 ................... The blower is used for blowing away leaves and other debris on the ground.
KEY TO SYMBOLS Symbol Descrlptien carried Locatio_ o_ _ ;yml el f the engine and disconnected tile spark plug _ intervals Cleaning is at required regulal _ X Applovedplotecfive goggles el visor must be X {_ _ ricochet and hit the operatoL This may cause sedous eye damage i.
SAFETY INSTRUCTIONS Personal safety equipment Muffler Persons who use the blower shall wear the following safety equipment: 1. Approved ear protection. 2. Approved eye protection 3. Approved protective gloves. 4. Boots or work shoes with a non-slip sole. 5. Face mask when operating the blower in dusty environments. The muffler is designed to give the lowest possible noise level and to direct the engine's exhaust fumes away from the operator.
SAFETY INSTRUCTIONS • Be careful, particularly if _ett hand operation is applied. Avoid any direct body contact with inlet cover area. Keep jewelry, loose clothing, or clothing with loosely hanging straps, ties, tassels, etc., away from inlet cover area. • Do not operate the blower while standing on a ladder or a stand. Other safety measures Operate the blower only at reasonable hours, i.e.
DESCRIPTION The blower 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. Shoulder strap (125BV x SERIES) Throttle trigger STOPswitch Variab{espeed control Fan housing Fuel cap Airfilter Choke Primer bulb Inlet cover 11 Vacuum handle (125Bx SERIES and 125BV x SERES) 12. Cutters (125B x SEREES and 125BVx SERIES) 54-5154658 Rev. 5 7/15/08 13. 14. 15. 16. 17. 18. 19. 20. 21. 22.
DESCRIPTION Accessories (125Bx_sERIESand 125BVx_sERIES) © .@ 21. 22. 23. 24. 25. 26. Vacuum device with collection Collection bag tube Collection bag Vacuum tube in two sections Screw Shoulder strap 545154658 Rev.
DESCRIPTION Safety equipment Other equipment The following equipment on the blower is designed for protecting personnel and materials. These components should receive special attention whenever you operate, inspect and service the blower. Throttle trigger • The speed and the output of the engine are regulated by the throttle trigger (C). Stop switch • The stop switch engine. (A) is used to stop tile j_ A .
DESCRIPTION Ground wire • The ground wire (G) reduces static beNd-up during operation in dry condb tions. ! Inlet cover • An inlet cover (H) is located on the side of the fan housing• Opening this cover allows access for cleaning and inspecting the impe,er (125Bx SERIES and 125BVx SERES only). If the vacuum tube is used. it must be fitted to the opening in the inlet cover• To open the inlet cover. use a tool to lift the edge of the cover opposite the hinge (indicated by arrow on inlet cover).
DESCRIPTION Choke • The choke (Q) is located below the air filter cover and should be used every time the engine is cold-started 'S%,-, 545154658 Rev. 5 j _ '2 7/15/08 Adjusting the carburetor NOT FOR ALL MODELS • There are three adjusting screws (R) for adiusting the carburetor: • Low speed jet • High speed jet • Adjustment screw for idling • Adjusting the carburetor involves adaptingthe engine to local operating conditions, e.g.
FUELHANDLING Fuel mixture CAUTION! The machine is equipped with a two-stroke engine and must always be run using a mixture of gasoline and twostroke engine oil. It is important to accurately measure the amount of oil to be mixed to ensure that the correct mixture is obtained. When mixing sinai+ amounts of fuel, even smelt inaccuracies can drasticaF ty effect the ratio of the mixture there • Always start by filling haft the amount of the gasoline to be used. Then add the entire amount of oil.
STARTING AND STOPPING Starting: Hold the body of the machine on the ground using your ]eft hand CAUTION! Not with your foot0. Firmly grip the starter rope handle with your right hand. DO NOT squeeze throttle trigger, Slowly pull out the cord until you feel some resistance (the starter paw_s grip); then quicMy and powerfully )u_l the cord. _1 WARNING: cord around Never wrap the starter your hand. J Pull starter handle unti_ engine attempts to run, but no more than 3 pulis.
USING THE BLOWER To blow away debris on the ground Fitting on the the blower blower &WARNING: er tube and be switched tube and nozzle !,½ : °i When fitting the blownozzle, the engine must off. The blower tube (T) has a begged slot mounting system to the unit.
USING THE BLOWER if the inlet cover is not closed, is damaged or cannot closed &WARNING: Never be start the blower (except if the vacuum tube is fitted). blower while &WARNING: a stand. standing on a ladder Do not operate the or Start the bbwer as described in the Starting and Stopping section. Work according to the following instructions: 1. Never blow air toward fixed objects such as wails, large rocks, automobiles and fences. 2.
USING Vacuuming Before vacuuming, safety equipment. _1 THE BLOWER put on tile required Always check and thatthe bag is intact zipper is closed before starting tbe blower. Never use a damaged bag. There is risk of injury due to flying debris. Be careful, particularly if left band operation is applied. Avoid any direct body contact with the exhaust outlet area.
MAINTENANCE Maintenance Safety The owner is responsible for the performance of all required maintenance as defined in the operator's manual. Disconnect the spark plug before performing maintenance, except carburetor adjustments. &WARNING: nance could damage tmproper mainteresult in serious engine or in serious injury. Carburetor Your Husqvama product has been designed and manufactured to specifications that reduce harmful emissions.
MAINTENANCE /CC EE _1 WARNING: Mufflersfitted with catalytic converters get very hot during use and remain so for some time after stopping. This also applies at idle speed. Contact can result in burns to the skin. Remember the risk of fire! Air filter WARNING: Engine exhaust Bear in mind that: fumes contain carbon monoxide, which can cause carbon monoxide poisoning. For this reason you should not start or run the machine indoors, or anywhere that is poorly ventilated.
MAINTENANCE Spark plug The spark plug condition is influenced by: • Incorrect carburetor adjustment. • An incorrect fuel mixture (too much or incorrect type of oil). • Poor quality gasoline and/or oil • A dirty air fitter. These factors cause deposits on the spark plug electrodes, which may result in operating problems and starting difficulties.
TECHNICAL Technical DATA data 125B Engine Cylinder volume, cu.Jn./cm3 Cylinder bore, inch/mm Stroke, inch/mm Idle speed, rpm Max. speed - bbwing, rpm: Max. speed - vacuuming, rpm: Max. engine output, acc.
WARRANTY SECTION 1: UMITED WARRANTY Husqvarna warrants Huegvama product to the original purchaser to be free from defects in material and workmanship from the date of purchase for the _VarraofyPeriod" of the products as set forth below: Lifetime Warranty: Ignition coifs and modules. 2 Year NON-COMMERCIAL Warranty: Blowers for non-commercial, non-prefessbnaJ,nondns_rtutionalor non-income producing use, except as herein stated.
U.S. EPA / CALIFORNIA EMISSION CONTROL / ENVIRONMENT CANADA WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS: The U.S. Environmental Protection Agency, California Air Resources Board, Environment Canada and HUSQVARNA are pleased to explain the emissions control system warranty on your year 2007 and later small off-toed engine. In California, all smai_ off-roed engines must be designed, built, and equipped to meet the State's stringent anti-smog standards.
U.S. EPA / CALIFORNIA EMISSION CONTROL / ENVIRONMENT CANADA WARRANTY STATEMENT MAINTENANCE, REPLACEMENT AND REPAIR OF EMISSION RELATED PARTS: Any HUSQVARNA approved replacement part used in the performance of any warranty maintenance or repair on emission related parts wilJ be provided without charge to the owner if the part is under warranty.
