User's Manual

1
Johnny Stewart Wildlife Calls
PM-4 Remote Digital Caller
Operating Instructions
PM-4 Remote Digital Caller
Your new PM-4 Remote Digital Caller is backed by 40 years of experience. The PM-4 will create incredible fun
and success for your enjoyment of the outdoors. Whether used for hunting, photography or observation of wildlife,
the PM-4 will create opportunities for you to experience nature up close in a dynamic way with Superior
Sounds…Dynamic Results.
Attractor Features:
1. Authentic Johnny Stewart Live Animal Recordings, Digitally Re-mastered.
2. Remote control operation up to 150 yards with remote 10 to 12 inches off ground.
3. Durable water resistant membrane keypad
4. Can play any two sounds at one time.
5. Speaker 1.08 lb, Base & Remote 1.19 lb =2.27 lb. total weight.
6. Holds 12 sounds (three cards x four sounds each). PM-4 is compatible with all J.S. Memory Cards.
7. Remote has 12 raised sound selection buttons and 1 raised stop button.
8. Interchangeable sound reference tabs for remote, to indicate selected cards in the base unit.
9. Continuous play.
10. 15 second sound loops.
11. 100 decibels* at full power.
12. Raised ON/OFF button on base Unit.
13. Remote is auto ON/OFF with sound selection or stop
14. Convenient Volume Control Switch on side of remote.
15. Red LED light card indicator on base.
16. Remote transmitter holder on back of base unit.
17. Speaker mount bracket on front of base unit.
18. 10 Foot extension cord for speaker.
19. One heavy duty nylon lanyard.
20. Lanyard loop on the top of the base unit to easily hang base or base and speaker.
POWER SOURCE
The PM-4 is powered by four AA batteries in Base Unit and a single 9 Volt battery in the Transmitter (batteries not
included). No need to fumble with screws on Base Unit or Remote to change batteries. Maximum performance is
provided by alkaline batteries. Note: The PM-4 will NOT shut down due to inactivity and remains powered until
Base Unit is manually shut off.
CALLING OPERATIONS
First place the required batteries in the remote and base units. Ensure that the batteries are installed correctly.
Improper battery installation will prevent the unit from operating. Locate base and speaker in desired location. Note:
you can use the 10 feet extension cord to separate the base and speaker if desired. Insert speaker cord jack into
the receptacle on the top of the base unit. Select the sound card(s) containing the sounds you desire, and insert
into PM-4. Push on sound card(s) until you feel it snap as the sound card engages the internal receptacle. Insert
the coinciding sound reference tab in the remote. Be sure that the reference cards are inserted into the same slot
(A, B or C) as the memory cards were inserted in the base unit. Turn base unit on by positioning the ON/OFF
switch located on the right side of the base unit. Begin calling by pressing the button on transmitter located next to
the desired sound. Selected sound will play continually until stop button is depressed on transmitter. Increase
volume by pushing the volume up button. Decrease volume by pushing the volume down button. Volume
automatically resets to the lowest setting each time the base unit switch is turned off. When finished with the PM-4,
be sure to switch the base unit off to conserve battery life.