Welcome For Your Records and Warranty Assistance Model Name: _____________________ Catalog/Model No.: ________________ Serial No.: _______________________ Date Purchased: ___________________ Where Purchased: _________________ For reference also attach your receipt or a copy of your receipt to the manual. Table of Contents 2 1 • Getting Ready ...................................................4 2 • Installing the Ceiling Plate..........................5 3 • Assembling and Hanging the Fan..........
Mounting and Optional Accessories Understanding Mounting Hunter’s patented mounting system provides you maximum installation flexibility and ease. You can install your Hunter fan in one of two ways, depending on your preference: Standard or Angle mounting. e steps in this manual include instructions for both mounting methods. Considering Optional Accessories Consider using Hunter’s optional accessories, including a wall-mounted or remote speed control.
1 • Getting Ready To install a ceiling fan, be sure you can do the following: • Locate the ceiling joist or other suitable support in ceiling. • Drill holes for and install wood screws. • Identify and connect electrical wires. • Lift 40 pounds. If you need help installing the fan, your Hunter fan dealer can direct you to a licensed installer or electrician.
2 • Installing the Ceiling Plate 2-1. Drill two pilot holes into the wood support structure through the outermost holes in the outlet box. e pilot holes should be 9/64” in diameter. 2-2. Your fan comes with four neoprene noise isolators (“Isolators”). Position the isolators between the ceiling plate and ceiling by inserting the raised areas on each isolator into the holes in the ceiling plate. Ceiling Plate Step 2-2 2-3.
3 • Assembling and Hanging the Fan Step 3-2 Glass Uplight 3-1. Install three 25 Watt Candelabra bulbs. 3-2. Place the glass uplight onto the fan assembly. 3-3. Insert the downrod through the canopy, canopy trim ring, and glass uplight. Feed the wires from the fan through the downrod. CAUTION: e downrod has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod. Fan Assembly 3-4.
4 • Wiring the Fan All wiring must be in accordance with national and local electrical codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician. 4-1. Disconnect the power by turning off the circuit breakers to the outlet box and associated wall switch location. 4-2. To connect the wires, hold the bare metal leads together and place a wire nut over them, then twist clockwise until tight. For all these connections use the larger wire nuts provided.
5 • Installing the Canopy and Canopy Trim Ring Step 5-2 Ceiling Plate 5-1. Holding the canopy, raise the fan off the hook. 5-2. Align the slots in the canopy with the tabs on the ceiling plate. 5-3. Raise the canopy over the ceiling plate. Rotate the canopy clockwise until the tabs on the ceiling plate totally engage with the slots in the canopy. Canopy Canopy Trim Ring 5-4. Loosely assemble the three canopy screws into the canopy one at a time. Once all three screws are in, tighten them. 5-5.