User's Manual

PowerView Scene Controller QuickStart Guide

Rev. 4

Buttons

– 1-press activation of favorite Scene

– 1-press activation of second favorite Scene

– activates Scene shown on display/Program mode/Program menu selections

- scroll buttons for cycling through Scene name list

PAGE 1
PowerView Scene Controller QuickStart Guide Rev.
PAGE 2
Configuring the Scene Controller You will need the PowerView Hub to be powered up and connected to a wireless router before configuring the Scene Controller. 1. Remove battery tabs to activate controller 2. 3. 4. 5. Press and hold the button for 4 seconds until the buttons begin to flash. Open the PowerView App on your mobile device.
PAGE 3
Battery Replacement: 1. Remove Cover. Press notch to move cover slightly clockwise to release and remove cover. 3. Replace Cover. Position cover over slots. Press notch to move cover slightly counterclockwise to lock into position. U.S. Radio Frequency FCC Compliance 2. Place Batteries. Use two CR 2032 3V batteries. Slide one battery into each compartment and press into place to fully seat. 4. Battery Removal To remove batteries use a small screwdriver or fingernail to lift battery and remove from slot.
PAGE 4
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FFCC CC Rules.