User's Manual

ManualsBrandsHunter Douglas Window Fashions ManualsElectronicsIF/RF Remote Control kit

Table Of Contents

Mercury Operating Instructions

Mercury Operating Instructions

Indicator LED

Channel Selector

Group 2

UP/DOWN

Group 1

Group 3

Group 4

All

Operation

Individual Mode

• By default, the shade will function on Channel 1. Ensure that the Channel

Selector is switched to Channel 1 by moving it to the left position. (If Channel

2 is desired, switch the Channel Selector to the right position.)

• Point the remote control at the window covering you wish to control. Try to point

at the receiver of the window covering as much as possible. While pointing,

briefly press the

UP or DOWN button as desired. A brief press of the button will

cause the desired shade to move continually in the desired direction. Note that the

Indicator LED lights red when pushing the UP or DOWN button. This

indicates that you are in Individual Mode.

Summary of content (4 pages)

PAGE 1
Mercury Operating Instructions Indicator LED Channel Selector UP/DOWN Group 1 Group 2 Group 3 Group 4 All Operation Individual Mode • By default, the shade will function on Channel 1. Ensure that the Channel Selector is switched to Channel 1 by moving it to the left position. (If Channel 2 is desired, switch the Channel Selector to the right position.) • Point the remote control at the window covering you wish to control. Try to point at the receiver of the window covering as much as possible.
PAGE 2
• To stop the shade, point the remote control at the window covering. While pointing, press either the UP or DOWN button. Either one will stop the shade. • If the shade is not stopped while moving, it will automatically stop at its end limit. Group Mode Please see programming instructions below before attempting to use the Group Mode. • In order to operate a group, the desired Group button must be pushed (Group 1, Group 2, Group 3, or Group 4).
PAGE 3
Programming Individual Mode No programming is necessary to operate window coverings in Individual Mode. The remote will operate the window coverings in Channel 1 right out of the box. If Channel 2 operation is required, follow these steps to change the channel on the window covering: • • • Switch the remote control to Channel 2 by sliding the Channel Selector to the right. Press and hold down the button on the receiver. Point the remote control at the receiver and press the UP button for three seconds.
PAGE 4
• When programming is completed, briefly press the Program button on the back of the remote control. The LED on the front should stop blinking, indicating that you are back in normal operating mode. • Clearing All Group Programming o To clear all of the group programming that has been done with a remote control, you must press the Reset button on the back of the remote for 10 seconds. o To access this button, remove the battery cover and press the recessed button with the end of a paperclip or a pushpin.