Remote Control Guide
Table of Contents Remote Control Buttons Thank you for your purchase of LEVOLOR® window coverings with motorized operating system. This guide will help you set up and operate your new remote control and help you understand functions and capabilities, allowing you to make the most of your new Sheer Shadings purchase. Table of Contents All Favorite Indicator Light Groupings Function Arrows, Open, Close, Tilt Programming Light Reset Button Remote Control Buttons.........................................
Explanation of Functions Explanation of Functions Once your remote is programmed, you will be able to operate and control the position and adjustment of your new window coverings with a touch of a button. You will be able to open/close and adjust the tilt position of the vanes. By setting up GROUPS and FAVORITES you will be able to perform all functions.
Explanation of Functions MANUAL CONTROL BUTTON A manual control button is located on the motor side of the headrail. This button can control the window covering without the remote. This button is also used to program your remote. Getting Started BATTERY PLACEMENT: 1. R emove the back cover, to expose the battery compartment. Manual Control Button STANDARD BATTERY PACK The standard power source provided with the Levolor motorized operating system.
Activating and Operating Activating and Operating JOIN A WINDOW COVERING TO A GROUP SET A FAVORITE POSITION NOTE: The LEVOLOR Remote will not operate a window Each shade has one FAVORITE position. Default setting is half way down with vanes closed. Setting a new FAVORITE position overwrites any previous setting. covering until the window covering has been added to a GROUP. 1. P ress and hold ■ STOP for 4 seconds to put the remote in program mode. 2.
Activating and Operating Additional Programming REMOVE A WINDOW COVERING FROM A GROUP 1. Press and hold ■ STOP for 4 seconds to put the 6. Press ▼ CLOSE to close the selected window covering(s). 7. P ress the RIGHT ARROW to close the window covering and open the vanes or rotate the vanes to the right. 8. Press the LEFT ARROW to close the vanes or rotate the vanes to the left. 9. Press ■ STOP to stop window covering/vane movement anywhere along its travel path. 10.
Additional Programming Reset Window Covering / Remote CREATING A DUPLICATE REMOTE RESET PROGRAMMING A duplicate remote will operate the same set of window coverings and GROUPS as the original remote. This reset erases all programming stored in the window covering, including GROUP assignments, preventing any remote from operating the window covering. Its primary use is during installation to correct GROUP assignments. 1. Remove the back cover from the new remote. 2.
Replacing Batteries BATTERY REPLACEMENT Replacing the batteries in the remote will not cause the loss of any window covering programming, including GROUPS and FAVORITE. The remote uses two Alkaline AAA batteries. To replace the batteries in the remote: 1. Slide open back of battery compartment. Trouble Shooting TROUBLE SHOOTING Problem Window Shading does not operate with the remote control. Solution Make sure the Indicator light on the remote control comes on when you try to operate the widow shading.
Compliance / Warranty U.S. RADIO FREQUENCY FCC COMPLIANCE STATEMENT U.S. Radio Frequency FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
©2017 LEVOLOR®, Inc.