User's Manual

ManualsBrandsHuman Touch ManualsRemote ControlsMedical Alarms Massage Chair

OTE:

Save all packaging materials - you will need them to package the existing chair properly for shipping back to Interactive Health.

CAUTION!

Your massage chair is a precision instrument that can be

damaged if dropped.

You will need at least

two people to complete this procedure,

Be sure you have enough people to lift and move the chair, to prevent injury.

List of components for packing (Fig.1):

(Fig.1)

SERVICE LEVEL:

lid (1)

ox base

(1)

Box shell

(1)

arge cardboard panel

(1)

oam panel

(1)

ardboard corner

spacers

(2)

ardboard and

foam corner

(2)

lastic bags

(2)

oam spacer

(1)

ardboard and foam

backrest spacer

(1)

Remote

control box

(1)

06/01/08

HT-2720

UNPACKING/PACKAGING THE CHAIR FOR SHIPPING

Summary of content (4 pages)

PAGE 1
06/01/08 UNPACKING/PACKAGING THE CHAIR FOR SHIPPING HT-2720 SERVICE LEVEL: 2 CAUTION! Your massage chair is a precision instrument that can be damaged if dropped. You will need at least two people to complete this procedure, Be sure you have enough people to lift and move the chair, to prevent injury. NOTE: Save all packaging materials - you will need them to package the existing chair properly for shipping back to Interactive Health. List of components for packing (Fig.
PAGE 2
UNPACKING THE CHAIR 1. Cut the shipping bands and open the box lid. 2. Remove the cardboard panel that covers the chair. 3. Remove the cardboard and foam corner spacers from each side of the headrest. 4. Remove the cardboard and foam backrest spacer from on top of the backrest. 5. Remove the cardboard corner spacers from each side of the bottom of the backrest. 6. Gently remove the backrest from the chair base. 7. Remove the foam spacer from on top of the chair base. 8. Remove the chair base.
PAGE 3
PACKAGE THE CHAIR 1. Place the foam panel on the bottom of the box. 2. Place the chair base into the box. 3. Place the foam spacer on top of the chair base (Fig.3). 4. Hold the backrest face-up, aligning the bottom of the backrest on top of the front of the chair base and the power panel on the back of the backrest with the square insert in the foam spacer. 5. Gently lower the backrest onto the chair base, guiding the power panel and remote control into the square insert in the foam spacer. 6.
PAGE 4
8. Place the cardboard and foam backrest spacer across the backrest (Fig.5). 9. Place the cardboard panel that covers the chair (Fig.6). 10. Close the box lid onto the box and secure it using shipping bands. Cardboard and foam backrest spacer (Fig.5) Cardboard panel (Fig.6) Please send any questions or comments regarding these instructions to: documentation@humantouch.com © 2008 Human Touch™, LLC.