MP6612i TABLE OF CONTENTS Introduction ..............................................................................................1 Installation ................................................................................................2 Wiring .......................................................................................................5 Front Panel Release ................................................................................6 Operation ..........................................
MP6612i ii
MP6612i INTRODUCTION Congratulations on your purchase of the Jensen MP6612i Mobile Receiver. It’s a good idea to read all of the instructions before beginning the installation. We recommend having your Jensen MP6612i installed by a reputable installation shop. • USB - Supports Hard Drives and Flash Memory Drives • SD Card - Playback of MP3 and WMA files • 3.5mm Audio Only Input Chassis Features CD / MP3 / WMA • Detachable Faceplate • 1.
MP6612i INSTALLATION 2. This unit is designed for installation in cars, trucks and vans with an existing radio opening. In many cases, a special installation kit will be required to mount the radio to the dashboard. These kits are available at electronics supply stores and car stereo specialty shops. Always check the kit application before purchasing to make sure the kit works with your vehicle.
MP6612i 2. CAUTION: For proper operation of the CD player, the chassis must be mounted within 20° of horizontal. 4. 5. 6. 7. 3. Place the radio in front of the dashboard opening so the wiring can be brought through the mounting sleeve. Follow the wiring diagram carefully and make certain all connections are secure and insulated with wire nuts or electrical tape. See “Wiring” on page 5. After completing the wiring connections, turn the unit on to confirm operation (vehicle ignition must be on).
MP6612i back until they lock, then pull the radio out. If removal keys are inserted at an angle, they will not lock properly and will not release the unit. Sleeve Removal Key Trim Ring Removal Key Technical Assistance If you require assistance, contact Technical Support at 1-800-323-4815 from 8:30am to 7:00pm EST Monday through Friday and from 9:00am to 5:00pm EST on Saturday.
MP6612i WIRING NOTE: The amplifier in this radio is only designed for use with four speakers. Never combine (bridge) outputs for use with two speakers. Never ground negative speaker leads to chassis ground. Failure to wire exactly as shown may cause electrical damage to the radio. NOTE: Only connect speakers with a nominal impedance of 4 ohms. Speakers with a load impedance less than 4 ohms could damage the unit.
MP6612i FRONT PANEL RELEASE The open button (1) releases the mechanism that holds the front panel to the chassis. Detaching the Front Panel To detach the front panel: 1. Press and hold the power button (2) to turn the unit off. 2. Press and hold the open button (1). The panel will slide down. You must press and hold to avoid ejecting the CD, if present. 3. Pull to release the right side of the panel. 4. Pull the left side of the panel to remove it. 5.
MP6612i OPERATION Power Press the power button (2) to turn the unit on. Press and hold the power button again to turn the unit off. MP6612i PH ONE ND NOTE: LCD panels may take longer to respond when subjected to cold temperatures for an extended period of time. In addition, the visibility of the numbers on the LCD may decrease slightly. The LCD display will return to normal when the temperature increases to a normal range.
MP6612i • • • LEVEL Turn the rotary encoder clockwise to increase or counter-clockwise to decrease the Bass level from “-6” to “+6”. “0” represents a flat response. Bass Center Frequency (C. FREQ) Turn the rotary encoder clockwise to adjust the Bass Center Frequency to 60, 80, 100 or 200Hz. Bass Quality Factor (BASS-Q) Turn the rotary encoder to select one of the following Bass Quality Factor options: 1N, 2N, 2W, 1W.
MP6612i Subwoofer (SUB-W) Programmable Turn-on Volume Level (VOL SEL) To adjust Subwoofer options, press the MENU button (22) until “SUB-W” appears in the display. Press the TUNE/TRACK >>| or |<< buttons (19) to access the following settings: • SUB-W Turn the rotary encoder to turn the subwoofer feature ON/OFF. • LEVEL The sub-woofer level control is only applicable if the unit is connected to an optional sub-woofer speaker.
MP6612i Reset Button The RESET button (4) is located on the front panel below the rotary encoder. The reset circuitry protects the microprocessor circuitry. Since resetting the unit will erase the time and preset memories, it should only be activated upon initial installation after all wiring is complete, or if there is a malfunction of any of the switches on the unit. In these circumstances, pressing the RESET button will clear the system and return the unit to normal operation.
MP6612i TUNER OPERATION Preview Scan Press the SCAN button (16) to scan all strong stations in the current band. The unit will stop at each station for five seconds before continuing to the next station. Press SCAN again to stop scanning and listen to the current station. The MP6612i allows you to receive channels in U.S.A. or EUROPE mode. See “Frequency Spacing (Area)” on page 9 to learn how to change the tuner options.
MP6612i • • • • • • • • • To 1. 2. Language (foreign) Religious Music Religious Talk Personality Public College Weather Emergency Test Emergency search for stations in a PTY category: Press the PTY button (17) to view the current PTY category. Turn the rotary encoder (22) to move through the list of available categories. 3. After 2 seconds of inactivity, the radio will automatically scan and play the first station it locates in the selected category.
MP6612i CD PLAYER OPERATION Insert CD 1. Press the OPEN/EJECT button (1) and the motorized front panel will slide down automatically to display the disc slot. • If a disc is already present, it will be ejected. Remove the ejected disc before proceeding. • Hold the OPEN/EJECT button for 2 seconds to open the front panel door without activating the eject function. 2. With the label surface facing up, fully insert a compact disc into the disc slot until the mechanism engages and pulls the disc in.
MP6612i MP3/WMA OPERATION MP3/WMA Encoder and CD Writer Settings MP3 and WMA (Windows Media Audio) music files are digital audio files that are compressed to allow more files on a single CD. This unit can play MP3/WMA directly from files contained on a CD-R/RW, SD card or USB device using the buttons on the receiver (or optional remote control) as described below. Many types of software are available for converting audio files into MP3/WMA formats. Jensen recommends Nero or Roxio Easy CD Creator.
MP6612i Loading an SD Card Insert the SD card, label side down, into the SD slot on the front of the MediaLink2. The unit will display “Card Read” and read the files on the card automatically. “SD” is shown in the upper left hand corner of the LCD when in SD mode. Bit Rates The unit supports bit rates from 32 - 320 kbps. MP3 Playing Order When selected for play, files and folders (Folder Search, File Search or Folder Select) are accessed in the order they were written by the CD writer.
MP6612i • Repeat (RPT) • Press the RPT button (10) once to select “RPT ON” and repeatedly play the current file. • Press RPT twice to select “RPT FOLD” and repeatedly play all files in the current folder. • To turn off repeat play, press the RPT button until “RPT” disappears from the display.
MP6612i 6. Press MENU to select a file or folder. 7. Repeat above steps as necessary. 8. Press and hold the MENU button to confirm and play the file Character Search 1. 2. 3. 4. 5. 6. Turn the rotary encoder (22) to highlight “Char Search”. Press MENU (22) to confirm. “Char INPUT, A” appears on the screen. Turn the rotary encoder to enter the first character (A-Z, 0-9, blank space). Press MENU to confirm. Repeat as necessary, entering at least two characters (8 maximum).
MP6612i SATELLITE RADIO OPERATION Selecting a Station Press the TUNE/TRACK >>| or |<< button (19) to change to another station. Listeners can subscribe to XM® Radio on the Web by visiting www.xmradio.com, or by calling (800) 967-2346. Customers should have their Radio ID ready (see “Displaying the Identification (ID) Code”). Customers can receive a limited number of free-to-air channels without activation. Preset Stations Press the BAND button (3) to change between three SAT Radio bands.
MP6612i Category Tuning Mode To select stations in a specific category, perform the following steps. 1. Press the AS button (15). 2. Turn the rotary encoder to select “Category Tune”. 3. Press the MENU button (22). 4. Turn the rotary encoder to move through the available categories. 5. Press the MENU button (22) to select the displayed category. 6. Once a category is selected, turn the rotary encoder to select stations in the current category. 7. Press MENU to select the displayed channel.
MP6612i iPod OPERATION Accessing iPod Mode Press the SRC button (7) to change to iPod playback mode. iPod playback begins automatically when an iPod is connected. Random (RDM) • Press the RDM button (11) once to select “RDM SONG” and randomly play all files on the source. • Press RDM twice to select “RDM ALBUM” and randomly play all files in the current folder. • To turn off random play, press the RDM button until “RDM” disappears from the display.
MP6612i BLUETOOTH OPERATION About Bluetooth Bluetooth is a short-range wireless radio connectivity technology that is developed as a cable replacement for mobile phones, handheld PCs and other devices. Bluetooth operates in 2.4 GHz frequency range and transmits voice and data at speeds up to 1 megabit per second. Bluetooth was launched by a special interest group (SIG) comprised of Ericsson Inc., Intel Corp., Nokia Corp.
MP6612i Use the TUNE/TRACK >>| or |<< buttons (19) to move the cursor and change an incorrect digit. Press the button to dial the call. • NOTE: Not all Bluetooth phones and features are compatible with the MP6612i (i.e HFP and phone book access). 3. NOTE: You can dial a number from any of the menu lists by highlighting the number and pressing the button (5). Connecting/Disconnecting Your Phone When the phone is out of range of the head unit (approximately 100 feet), it will automatically disconnect.
MP6612i 6. 7. Use the rotary encoder to enter a name to identify the number, pressing ENTER after each entry. You can enter up to 10 characters (digits and/ or letters) on the second line. After the last character, press ENTER again to finalize your entry. a call from the Missed list, turn the rotary encoder (22) to select the number and then press the button (5). The LCD will display “Empty” when the feature is not available.
MP6612i • AVRCP: Play back, pause, select songs, etc. while streaming audio from your Bluetooth compatible audio player to the MP6612i. NOTE: Song information (e.g. elapsed playing time, song title, song index, etc.) cannot be displayed on this unit. Since there are a number of Bluetooth audio players available on the market, operations with your Bluetooth audio player using this unit vary greatly.
MP6612i REMOTE CONTROL Replacing the Battery When the range of operation of the card remote control becomes short or stops functioning, replace the battery with a new lithium battery. Be sure to observe the proper polarity, as indicated below. The remote control will allow you to control many functions of the MP6612i. 1 2 3 / INT RPT 4 5 6 7 8 9 * 0 # (CR 2025) RDM SRC 1 VOL Operating Range The remote control sensor (20) is located to the right of the PHONE button.
MP6612i CARE AND MAINTENANCE CD Player The following guidelines will help you extend the life of your CD player: 1. When cleaning the vehicle interior, do not get water or cleaning fluids on the unit. 2. The CD player will not operate properly in extreme hot/cold or under damp conditions. In case of such conditions, wait until the vehicle interior reaches a normal temperature or any condensation on the disc player lens has evaporated before using the player. 3.
MP6612i TROUBLESHOOTING Problem Does not operate (display does not light) Cause No power to yellow wire; no power to red wire Inline fuse blown No power to unit Inline fuse blown No speakers oper- No speaker harness, ate (display lights speakers not connormally) nected Not all speakers Incorrect splices or operate connections Speaker wires shorting to chassis ground or to each other Blows fuses Power wire shorting to ground Speaker wires shorting to ground Incorrect fuse; fuse too small Corrective Action
MP6612i SPECIFICATIONS General CEA Power Ratings Power Supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 to 16VDC, negative ground Power Antenna (Blue) . . . . . . . . . . . . . . . . . . . . . . . . . 500mA max, current limited protection Operating Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -20C ~ 65C Fuse . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Limited Warranty DO NOT RETURN THIS PRODUCT TO THE STORE CD or Multimedia Radios/Headunits Audiovox Electronics Corporation (“the Company”) is committed to quality and customer service, and are pleased to offer you this Warranty. Please read it thoroughly and contact the Company at 1-800323-4815 with any questions. Who is covered? The Company extends this warranty to the original retail purchaser of products purchased through an authorized Audiovox retailer in the U.S.A., Puerto Rico or Canada.
AudiovoxElectronics ElectronicsCorporation Corporation Audiovox Hauppauge,NY NY11788 11788 Hauppauge, TechnicalAssistance: Assistance:1-800-323-4815 1-800-323-4815 Technical www.jensen.com www.jensen.com 2007Audiovox Audiovox ©©2007 Ver.013007 080307 Ver.