Centre Outdoor Sconces 302610 & 302612 B401 ASSEMBLY & INSTALLATION INSTRUCTIONS MODERN AMERICAN BLACKSMITHS | FINE, HAND CRAFTED LIGHTING CASTLETON, VERMONT USA | HUBBARDTONFORGE.
Centre Outdoor Sconces 302610 & 302612 B401 ASSEMBLY & INSTALLATION INSTRUCTIONS Component Parts A Fixture B Front Tube C Thumb Screw (4) D Rubber Washer (6) E Mounting Bracket F Ground Screw G Cupped Washer H Caulking Lip I #8 Screws (4) J Glass (2) K Anchor (4) L Flat Head Screw (4) M Set Screw (2) N Socket O Bulb (2 - Included) MODERN AMERICAN BLACKSMITHS | FINE, HAND CRAFTED LIGHTING CASTLETON, VERMONT USA | HUBBARDTONFORGE.
B401 ASSEMBLY & INSTALLATION INSTRUCTIONS Centre Outdoor Sconces 302610 & 302612 CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.* Caution: Do not exceed maximum wattage noted on fixture.
B401 ASSEMBLY & INSTALLATION INSTRUCTIONS Centre Outdoor Sconces 302610 & 302612 F G I D Triangle Plate E MACHINE SCREWS A (Figure 2) H (Figure 3) MODERN AMERICAN BLACKSMITHS | FINE, HAND CRAFTED LIGHTING CASTLETON, VERMONT USA | HUBBARDTONFORGE.
B401 ASSEMBLY & INSTALLATION INSTRUCTIONS Centre Outdoor Sconces 302610 & 302612 To Prepare Glass (Figure 4 ) 1. Unpack glass (J). 2. Place glass on a clean surface. Press anchors (K) into holes in glass from each side until anchor is flush with side of glass. J 3. Locate front tube assembly (B). Place glass into front tube with frosted surface oriented as shown in Figure 4. Note: It may be necessary to loosen set screw (M) to allow glass to pass into tube. K 4.
B401 ASSEMBLY & INSTALLATION INSTRUCTIONS Centre Outdoor Sconces 302610 & 302612 To Complete Installation (Figure 5) BACK VIEW B 1. Install bulbs (O) (included) into sockets (N). A 2. Orient front tube (B) assembly so thumb screws and washer still installed are toward the top. D 3. Front tube (B) assembly can only be installed one way. A hole in front tube will need to line up with the alignment stud on the fixture (A). C 4.