Installation Instructions

ManualsBrandsHubbardton Forge ManualsLightingArbo 1-Light Wallchiere

HUBBARDTONFORGE.COM

-, -   

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

31849

Installation Instructions

If you need further assistance, or nd that you are missing any parts, please contact the dealer from which you purchased this

product. We hope you enjoy your xture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this xture.

Please Note: This fixture is designed to be mounted on a standard wall surface

and may not be suitable for all applications. If installing in a non-wood frame

application, we recommend consulting a qualified builder or electrician.

To Mount Fixture to Wall (Figure 1)

Component Parts

A Crossbar

B Threaded Stud (2)

C Knurled Balls (2)

D Fixture Assembly

E Ground Screw

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX

PRIOR TO INSTALLATION.

1. Carefully unpack the xture from the carton.

2. Using two machine screws (not provided), fasten the cross-

bar (A) to the electric box making sure that xture mounting

holes are level.

Note: A new electric box comes with screws. When replacing a

xture, retain the existing screws for use with the new xture.

3. Thread studs (B) into the appropriate holes in the crossbar

(A). Adjust the studs to proper length to ensure the fixture

will fit snugly to the wall.

4. Hold the fixture assembly (D) close to the wall and using

suitable wire connectors, not provided, connect fixture wires

to supply (white to white and black to black). Run a pigtail

lead from crossbar ground screw (E) to the junction box and

connect all ground wires (bare copper or green to bare cop-

per or green).

CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON

SECURELY, AND NO BARE WIRE IS EXPOSED.

5. Slide fixture assembly (D) over threaded studs (B) and push

firmly to wall, making sure that no wires are pinched be-

tween fixture back and wall. Fasten with knurled balls (C).

Be sure threaded studs (B) are fully seated in the knurled

balls (C).

6. See instructions on next page to install shade.

B330

For Arbo Sconce 207640

Page 1 of 2

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND

PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with

applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.

(Figure 1)

(Continued)

Summary of content (2 pages)

PAGE 1
B330 Installation Instructions For Arbo Sconce 207640 Page 1 of 2 CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.* Caution: Do not exceed maximum wattage noted on fixture.
PAGE 2
B330 Installation Instructions For Arbo Sconce 207640 Page 2 of 2 To Mount Fixture to Wall (Figure 2) Component Parts D Fixture Assembly F Shade 1. Install light bulbs (not included). F 2. Slip shade (F) onto fixture assembly (D) so it rests against wall. 3. Restore electricity at main breaker. D (Figure 2) If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.