Corelink You and Me --Zhilian future User manual Infrared people counter MODEL: HX-HE1 First of all, we would like to express our most sincere thanks to you for purchasing our products. Please read this manual carefully and use it correctly. The warranty is enclosed in this manual, please keep it properly and take it out for reading when necessary. www.huaxinlot.com.
Corelink You and Me --Zhilian future HX-HE1 infrared passenger flow counter is an ultra-small, battery-powered, WIFI transmission passenger flow counting terminal, which provides a quick deployment, simple and efficient passenger flow statistics solution for various chain stores, supermarkets, scenic spots, libraries and other places .
Corelink You and Me --Zhilian future Yellow indicator light: As a battery alarm and charging indicator, when the battery voltage is too low, the indicator flashes to remind you to charge or replace the battery. When the battery is charged through the USB interface, the indicator light is always on. Blue indicator light: indicates WIFI network transmission or data storage instructions.
Corelink You and Me --Zhilian future ① LED indicator Red indicator light: As a battery warning indicator, when the battery voltage is too low, the indicator light flashes to remind you to charge or replace the battery. Blue indicator light: As a self-check indicator, when the battery is installed, the blue light flashes 3 times and then goes out, indicating that the device is normal.
Corelink You and Me --Zhilian future 二、Introduction to screen display The OLED display can be awakened by touching the light-transmitting bar (touch-sensing antenna position) with your hand. When the OLED display is on, the display content of the OLED display will be switched every time you touch it, which can display: The device will bounce every time it is powered on, indicating the strength of the infrared signal currently received, so that on-site personnel can check whether the device is aligned.
Corelink You and Me --Zhilian future Current operating business hours range Outside business hours, the passenger flow counting terminal automatically enters the dormant state, during which no counting is performed, and the business start time is automatically activated.
Corelink You and Me --Zhilian future that the network is successfully connected. After the passenger flow counting terminal starts the AP service (WIFI hotspot), if there is no mobile phone connected to the "HXZY" network within 30 seconds, the AP service will be automatically closed. Therefore, you need to pay attention to the countdown on the passenger flow counting terminal screen, and the countdown will restart every time you touch it again.
Corelink You and Me --Zhilian future 3 、 Passenger flow counting terminal configuration interface Open the browser, enter: 192.168.8.1 in the browser address bar, press Enter (GO) to enter the passenger flow counting terminal setting page. The initial password is 1234, you need to enter the password to log in before you can select and set the content.
Corelink You and Me --Zhilian future 5、Networking configuration If the data needs to be reported to the cloud platform, enter the "Network Configuration" to configure the WIFI network name, password and server address provided by the store. NOTE: Before configuration, you need to prepare a smart phone with WIFI function to complete the subsequent configuration work. Tip: The passenger flow counting terminal starts the AP service (WiFi hotspot mode) is very power-consuming.
Corelink You and Me --Zhilian future NOTE: The passenger flow counting receiving terminal is installed on the right side of the pedestrian entering direction at the entrance and exit, the passenger flow counting terminal USB interface is facing downwards, and the passenger flow counting terminal infrared receiving unit faces the infrared transmitter. Use the matching double-sided tape or screws to fix the passenger flow counting terminal at a height of 1.
Corelink You and Me --Zhilian future a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.