Tripod Selfie Stick (Wireless Version) Quick Start Guide
English Connecting to your phone 1 Press and hold the camera button on the selfie stick for 2 seconds to enter Bluetooth pairing mode. 2 Enable Bluetooth on your phone search for available devices. Select AF15. If the selfie stick successfully pairs with your phone, the green indicator will be on for 3 seconds and off.
English Using the selfie stick 1 Expand the selfie stick. 2 (Optional) Open the tripod at the bottom, push the pole upwards, and place the tripod on a horizontal level surface.
English 4 Set the volume button on your phone 3 Attach your phone on the selfie stick. to act as the shutter button. Use the remote control to take a photo.
English Replacing the remote control battery Remove the Bluetooth remote control from the tripod. Push against the battery cover in the direction shown by the arrow and replace the battery.
English Powering off the selfie stick Press and hold the camera button on the selfie stick for 3 seconds until the green indicator light turns off. Note: ● If you do not use the remote control for 3 minutes, it will automatically enter sleep mode and disconnect from your phone. The remote control will be powered off if you do not use it for 6 hours. ● The Bluetooth range for the remote control is 10 meters.
The statements should be displayed in the user manual: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.