User Manual Solar&Wireless Photoelectric Beam Sensor
1. Configuration List Solar&Wireless Photoelectric Beam Sensor 1 pairs (includes 1 set installation accessories) English Manual 1 piece 2.
● Screw Hole ON/OFF● ● Charge Jack ● ● Charge Jack● ● ON/OFF Receiver Transmitter Horizontal Pipe: easy to know the beams be installed vertically Infrared Beam: used to detect the intruder Calibration Hole: easy to align with another beam sensor if the beams apart far away Solar Panel: charge the battery of the beam sensor even in cloudy or rainy days ON/OFF: turn on/off the solar beam sensor（press the ON/OFF button once） Charge Jack:pull out the red plug to charge the solar beam sensor by DC5V-12V po
Step 2 Step 3 Make sure the beams aligned with each other Trigger The Solar&Wireless Photoelectric Beam Sensor(Completely block all the 2 infrared beams) ON/OFF● ● ON/OFF ● ON/OFF Transmitter Receiver (if work normally,the light of the Receiver's ON/OFF button will go off after flashing about 10 seconds; and the light of the Transmitter's ON/OFF button will go off after about 30 seconds ) Transmitter 4.
R T T R Calibration (1)Place the beam sensor on the same height. (2)Ensure the beam sensor is vertical(the bubble of the horizontal pipe should be in the middle). (3)Adjust the direction of the beam sensor to make them align with each other Calibration Hole: used to find another device (4)If work normally,the light of the Receiver’s ON/OFF button will go off after flashing about 10 Seconds. (5)Tighten the screws to ensure the position and direction will not be moved easily.
2 nd Installation method(with iron brackets) 5
R T T R Calibration (1)Place the beam sensor on the same height. (2)Ensure the beam sensor is vertical(the bubble of the horizontal pipe should be in the middle). (3)Adjust the direction of the beam sensor to make them align with each other Calibration Hole: used to find another device (4)If work normally,the light of the Receiver’s ON/OFF button will go off after flashing about 10 Seconds. (5)Tighten the screws to ensure the position and direction will not be moved easily. 5.Product Dimension 1.
6.Technical Parameters 7 Item Technical Parameters Infrared Detection Range 190 feet Wireless Transmission Range 1/4 mile Beam Quantity 2 Wireless Frequency 433MHz FSK+FHSS Maximum Trigger Number In 24 Hours ≤200 times Working Voltage 3.3V Battery Type Chargeable LiFePO4 Battery Battery Capacity Transmitter:500mAh,Receiver:500mAh Static working Current ≤0.
