Wireless Alarm System User Manual
1. Configuration List Wireless Alarm Receiver Wireless Motion Sensor Solar Panel English Manual 1 piece(includes 1 power adapter) 1 piece(includes 1 set installation accessories) 1 piece(includes 1 set installation accessories) 1 piece Note:The alarm system has been programmed already,please operate the system according to the part 3 of the manual; If you want to add additional the sensors to the system,please operate the system according to the part 4 of the manual or contact us directly; 2.
Power Tone ON/OFF Power : power jack(DC5V) ON/OFF: power switch(turn on/off the wireless alarm receiver) set button(add/delete the sensors of the wireless alarm receiver) Tone: Choose the ring tones(total 35 ring tones optional) Volume:Press and hold the“ON/OFF”button first,and then press the“Tone”button to adjust the alarm volume,total 4 volume levels.
Solar Panel Solar Panel Solar Panel: charge the battery of the motion sensor (face to the sunlight as possible as you can) Connection Cable Connection Cable: the length is 1.8 meters,used to connect to the charge jack of the motion sensor 3.
Step 2 Turn on the Wireless Motion Sensor: Press the ON/OFF button 4 times; ON/OFF (press 4 times) (bleep prompt means work normally) Step 3 Activate The Wireless Motion Sensor (wait about 30 seconds after you turned on the sensor) 1st method:press the ON/OFF button twice ON/OFF (press twice) (the light of the ON/OFF button will flash once means the motion sensor was activated and sent the alarm signal) 2nd method: Ensure the sensor is turned away from you.
Step 4 Press“Tone” button to choose the ring tone for this sensor, there are 35 tones to choose from;(up to 32sensors can be connected to 1 receiver;match different tones with different sensors) Tone Step 5 Adjust the alarm volume. Press and hold the“ON/OFF”button first,and then press the“Tone”button to adjust the alarm volume, total 4 volume levels.
Step 6 Installation Wireless Motion Sensor Solar Panel long screws long screws short screws 6 short screws
Installation Notes: 1. Please install the solar panel face to the sunlight or in a good light condition environment as possible as you can 2. Please fix the motion sensor . tightly to ensure the position and the direction will not be moved easily by wind. 3.Please point the sensor towards 4.
4.
Step 5 Press“Tone ”Button to choose the ring tone for this sensor, there are 35 tones to choose from(up to 32sensors can be connect to 1 receiver;match different tones with different sensors sensors ) Tone (2)How to delete the sensors of the wireless alarm receiver Step 1 Power on the wireless alarm receiver by the power adapter; Step 2 Press and hold both the “ON/OFF” button and “Tone ”button for 10 seconds and release the buttons when you heard a long bleep; Note: all the sensors will be deleted by this
(4)How to change the ring tone for the sensors Step 1 Power on the wireless alarm receiver by the power adapter ; Step 2 Activate the sensor first,and then press the "Tone" button to choose the ring tone for this sensor; Same steps for other sensors which have been added to the wireless alarm receiver already.
Wireless Motion Sensor 90mm 130mm 85mm Solar Panel 187mm 157mm Technical parameters Item Technical Parameters Detection Range 65 feet(20m) Detection Angle 15 Wireless Transmission Range 1/2 Mile(800m) Wireless Frequency 433MHz FSK+FHSS Working Voltage 3.