Wireless Alarm System User Manual
1. Configuration List Wireless Alarm Receiver 1 piece (includes 1 set installation accessories) Solar&Wireless Photoelectric Beam Sensor 1 pairs (includes 1 set installation accessories) English Manual 1 piece Note: The alarm system has been programmed already,please operate the system according to the part 3 of the manual; If you want to add additional detectors to the system,please operate the system according to the part 4 of the manual or contact us directly; 2.
Power Tone ON/OFF Power : power jack(DC5V) ON/OFF: power switch(turn on/off the wireless alarm receiver) set button(add/delete the sensors of the wireless alarm receiver) Tone: Choose the ring tones(total 35 ring tones optional) Solar & Wireless Photoelectric Beam Sensor Horizontal Pipe Infrared Beam Calibration Hole Infrared Beam Solar Panel Receiver Transmitter ● Screw Hole ON/OFF● ● Charge Jack ● ● Charge Jack● ● ON/OFF Transmitter 2 Receiver
Horizontal Pipe: easy to know the beams be installed vertically Infrared Beam: used to detect the intruder Calibration Hole: easy to align with another beam sensor if the beams apart far away Solar Panel: charge the battery of the beam sensor even in cloudy or rainy days ON/OFF: turn on/off the solar beam sensor（press the ON/OFF button once） Charge Jack:pull out the red plug to charge the solar beam sensor by DC5V-12V power adapter if the battery of the beam sensor go flat Screw Hole: used to fix the instal
Step 3 Make sure the beams aligned with each other ON/OFF● ● ON/OFF Transmitter Receiver (if work normally,the light of the Receiver's ON/OFF button will go off after flashing about 10 seconds; and the light of the Transmitter's ON/OFF button will go off after about 30 seconds ) Step 4 Trigger The Solar&Wireless Photoelectric Beam Sensor, and the wireless alarm receiver will alarm for 5seconds (Completely block all the 2 infrared beams) ● ON/OFF Transmitter Receiver (the light of the Receiver's ON/O
Step 6 Installations Solar&Wireless Photoelectric Beam Sensor 1st Installation method 5
6
4.
Step 3 Trigger the sensor (for example,trigger the solar&wireless photoelectric beam sensor) stop flashing (a ring tone prompt and the indicator light stops flashing means the sensor has been added to the wireless alarm receiver successfully) Step 4 Trigger the sensor again to confirm the sensor has been added to the wireless alarm receiver already.
(3)How to adjust the alarm volume Step 1 Power on the wireless alarm receiver by the power adapter Step 2 Press and hold the“ON/OFF”button first,and then press the“Tone”button to adjust the alarm volume,total 4 volume levels ON/OFF Tone (4)How to change the ring tone for the sensors Step 1 Power on the wireless alarm receiver by the power adapter Step 2 Trigger the sensor first,and then press the "Tone" button to choose the ring tone for this sensor; Same steps for other sensors which have been added to
Solar&Wireless Photoelectric Beam Sensor Technical parameters Item 10 Technical Parameters Infrared Detection Range 190 feet(60m) Wireless Transmission Range 1/4 Mile(400m) Beam Quantity 2 Wireless Frequency 433MHz FSK+FHSS Maximum Trigger Number In 24 Hours ≤200 times Working Voltage 3.3V Battery Type Chargeable LiFePO4 Battery Battery Capacity Transmitter:500mAh,Receiver:500mAh Static working Current ≤0.
