Installation Instructions

Product Introduction Loading Paper Roll
01
Accessories
Operation LED
Indicator
Cover-opening
Button
Power
Button
Cover-opening
Button
USB Interface
Front View：
Rear View：
USB Cable×1
02
01 Open the top cover
02 Remove the paper roll
Push the cover-opening buttons on both sides,and open the top cover.
Remove the supplied paper roll and tear it apart along the edge.
03 04 05
Loading Paper Roll
03 Load the paper roll
Load the paper roll to the paper compartment again and pull some extra
paper.Please adjust the separator according to the paper width.
04 Close the top cover
Close the top cover after loading paper.Please make sure both sides click
into place.
Printing Wirelessly from Mobile Phone
Scan the QR code below to download “Hiprint”App.
Tip: Default page by page printing mode.Click the power button to continue
printing after one page is printed.For continuous printing, go to the printer driver
setting and set it to continuous printing mode.
01 Download App
02 Connect the Printer
Power On
Battery Charging
Note: App operation shall be subject to the latest version. Please purchase and use HPRT official thermal paper.
01 Power on
Hold down the power button for 3 seconds to start the printer.
06
Precau�ons
℃℃, 





Printing from Windows PC
Connect one side of the USB cable to the PC and the other side to the printer.
Turn on the printer.
Download the driver program from HPRT website,and install it in the PC.
Add the printer to the PC and print the documents from the PC after
establishing the connection.
Open App, click “+”in the top right corner,select MT series，Select “connect
via 'system settings'”,mobile phone bluetooth select“MT810-XXXX”（XXXX is
last four digits of Bluetooth address）,click and connect.
Return “Hiprint”App,and click the device and connect.
Open the document to be printed on the mobile phone and copy it to
"Hiprint"；（Or select document printing on the App home page）.
Set it in the print preview as required, and then click “Print”.
03 Printing
When the battery is low, the indicator light will flash (red light flashes quickly).
Please use the matching USB cable to charge in time. If you continue printing,
the printer may shut down automatically.
charging by PC
charging by power adapter
cover-opening button
Separator
Connection LED
Indicator
