Assembly & Installation Instructions

ManualsBrandsHouse of Hampton ManualsCeiling LightsBernier 3 - Light 14" Shaded Drum Flush Mount

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES 1 Before installing consult local electrical codes for wiring and grounding requirements: . , .

2. READ AND SAVE THESE INSTRUCTIONS

Outlet Box

House Grounding Wire

Wire Connector (E)

Lock Nut (F)

Fixture Mounting Screw D

Bulb Type B Max.

60W (not included)

( )

Ceiling Pan

Socket

Coupling

Washer (L)

Glass Shade

Cover H( )

Finial G( )

Mounting Strap A( )

Green Grounding Screw C( )

Mounting Screw B

( )

Hardware Package (included) :

Mounting Screw B

( )

Green Grounding

Screw (C)

Wire Connector (E) Lock Nut (F)

Mounting Strap A

( )

Fixture

Mounting Screw D

( )

Cover H

( )

Finial G

( )

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK BE SURE TO SHUT OFF,

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE .

Turn off the power at fuse or circuit box

Threaded Pipe (I)

1. Attach the two fixturemounting screws to the holes on the

mounting strap,and screw them in 2 to 3 turns.

2 Attach the mounting strap to the outlet box using two

mounting screws.

3 Pull out the source wires from the outlet box.

Make wire connections using wire connectors

as follows:

---Connect the hot wire (usually black insulation)

from the fixture to the black wire from the power source.

---Connect the neutral wire (usually white insulation)

from the fixture to the white wire from the power source.

---Attach the fixture grounding wire (usually green insulation

or bare wire) to the mounting strap with the green grounding

screw, and then connect it to the house grounding wire with the

wire connector.

Carefully put the wires back into the outlet box.

Installation Steps

Fig.1

Tube W / Threaded Pipe (I)

Metal Pad (J)

Hex Nut (K) Washer (L)

Hex Nut (K)

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK ,BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE . NOTES: 1. Before installing ,consult local electrical codes for wiring and grounding requirements 2. READ AND SAVE THESE INSTRUCTIONS .
PAGE 2
4. Attach the ceiling pan to the mounting strap by inserting two fixture mounting screw heads into the key hole, and rotate the pan until it is locked in place. Then secure the screws tightly. ( See Fig.1) 5. Screw the tube with the threaded pipe head into the coupling until tightened. 6. Install bulbs (not included), See relamping label at sccket area or packaging for maximum allowed wattage. 7. Secure the nipple into the tube. Adjust the nipple to the suitable location. 8.