Instruction for Use

12
Guide to the refrigerator/freezer and ice/water dispenser control panel
Water filter indicator light function (if present)
The water filter indicator light indicates when to change the water filter cartridge.
When the light changes from green to yellow, this means that it is almost time to change the water
filter cartridge (90% of the filter life has been used).
The water filter cartridge should be replaced when the water filter indicator light changes to red.
After changing the water cartridge, reset the water filter indicator light by pressing the corresponding
switch for 3 seconds.
The indicator light will change from red to green when the system is reset.
Dispensing water
To dispense water press a glass against the water dispenser lever and to stop dispensing remove the
glass; the light inside the dispenser turns on simultaneously and turns off when the lever is released.
Hold the edge of the glass close to the dispenser opening so water does not spill out of the glass. The
water tank is located in the refrigerator compartment behind the two lower drawers.
Note:
Pressing hard will not make the water dispenser operate faster or produce greater quantities.
Removing and rearranging the refrigerator and freezer
shelves
The shelves can be positioned as required.
The glass shelves are strong enough to hold bottles, milk cartons
and heavy food; however, please don’t bang them down on the
shelves.
To remove the shelves:
slide the shelf out as far as it comes, then lift it up and take it out.
Removing the crisper or meat drawer:
•
slide the drawer out as far as it comes;
•
with one hand underneath the drawer, lift it up and pull it out;
•
the drawer will come out of its runners and can be pulled out
further;
•
to remove completely, the drawer will need to be rotated:
front end up, back end down.
To remove the glass cover of the drawer
•
Lift the front of the frame 10 cm, then with your other hand,
lift the back of the frame and pull it out.
To put the glass cover of the drawer back
•
Insert the back of the frame in the supports on the
refrigerator walls and lower it back into place.
Meat drawer temperature control
•
The cold air flows into the meat drawer through an opening
between the refrigerator and the freezer compartment. In
this way the temperature inside the meat drawer is lower
than in other parts of the refrigerator. Set the slider for higher
or lower airflow.
•
If you wish to store vegetables in the meat drawer, move the
control all the way to the left to the vegetables setting. This
avoids possible frost damage to the vegetables.
•
When the fast freeze function is activated, the slider must be
set to “vegetables”.
63702001GB.fm Page 12 Friday, September 8, 2006 6:51 PM