Use and care guide

28
Any problems or malfunctions that may occur can often be easily resolved.
Before contacting the After-sales Service, check the following table to see whether you can resolve the
problem yourself.
If the problem persists, contact your nearest After-sales Service Centre.
TROUBLESHOOTING
Problem Possible cause Solution
The oven is not working.
Power cut.
Disconnection from the mains.
Fault.
Check for the presence of mains electrical
power and whether the oven is connected
to the electricity supply.
Turn o the oven and restart it to see if the
fault persists.
The oven is not heating up.
Function selected.
Select a dierent function. Turn o the oven
and restart it to see if the fault persists.
Door open. Close the door and see if the fault persists.
The time is flashing.
Power cut.
You need to reset the time: Follow the
instructions given in the “Using the
appliance for the rst time” section.
The display shows the letter “F”
followed by a number.
Software fault.
Contact you nearest Client After-sales
Service Centre and state the number
following the letter “F”.
The door will not close properly.
The safety catches are in the wrong
position.
Make sure that the safety catches are
in the correct position by following the
instructions for removing and retting the
door in the “Maintenance” section.
Cooking will not start and/or an
audible signal sounds.
The selected function is not
compatible with the action you wish
to perform.
Select the function again. Remove and then
reinsert the meat probe.
The light switches off during
cooking.
ECO function activated.
From the “Settings” - “ECO” section, select
the “No” option to deactivate it.
Read the safety instructions carefully before carrying out any of the following work