Installation Instructions Overthe Range Microwave Oven I Questions?Call 800.GE.CARES(800.432.2737)or Visit,,,,_x_ebsite;,t:Hotpointcom BEFORE YOU BEGIN Read these instructions completely • IMPORTANT instructions for local • Note codes and to Installer instructions carefully. - S_,,e these inspector's use. - Obse_,'e _,ll • IMPORTANT governing and ordinances. - Be sure to leave these ° Note to Consumer instructions for future - KeeI) these reterence.
Installation Instructions _] CONTENTS General information hnportant Safety Redrculating ........................................ Attach Mounting Preparation Electrical Hood Instructions Requirements Exhaust .................................. Parts Included. Tools Mounting of Mounting Finding Plate Detemiiuiug Top Plate Plate 8-10 8 Prepm;lfion Install Mount of Top 11-22 to _4"dl ....... Cabinet the Damper .......... ..................
Installation Instructions IMPORTANT SAFETY INSTRUCTIONS This product requires The installer must on the power installation (under outlet box to insure grounded, box a three-i)rong peril)ira If not does not electrician deficiencies, ineet should heft)re that i)roi)erly the begilming outlet box properly Where outlet noted with any Code a three-prong plug which staaadaJ_d (grounding) of this with (grounding) mates with a three-prong wall receptacle to mh_hnize the po
Installation Instructions HOOD EXHAUST NOTE: Read outside. If you these next plan OUTSIDE two pages to recirculate only the if you air back TOP EXHAUST The following chart ductwork installation. describes plml to vent into the your room, (EXAMPLE an example ot one exhaust to the proceed to page 6. ONLY) possible EQUIVALENT LENGTH DUCT PIECES 12 Ft.StraightDuct RoofCap (6" Round) x 12 Ft. 24 Ft. TransitionAdaptor* Rectangular-to-Round xx 5 Ft.
Installation NOTE: duct If you length round duct Outside Read NOTE: the to install should not ventilation the direct blockages, nothing is blocking The hood a standard exceed that the total Maximum DUCT. For s;Kisfhctorv air movement, the total duct length of 3¼" x l 0" rectangular or 6" diameter round duct should not exceed 140 equivalent feet. or 6" diameter 140 equivalent a HOOD that route clear Also, Exhaust note feet. EXHAUST carefiflly.
Installation Instructions PARTS INCLUDED DAMAGE--SHIPMENT/ INSTALLATION HARDWARE " If the unit unit is damaged to the store in shipment, in which it was return bought the PART QUANTITY fin" repair or rel)laceu/ent, " If the unit is dainaged replacement • If the than unit the is the by the customer, responsibility is damaged customer), be made by arrangement and installer.
Installation Instructions TOOLS YOU WILL NEED Ruleror tape measureand # 1 and#2 Phillipsscrewdriver Pencil ...... r..,..r.,..r.,..r.,.T.,..r.,..r.,..r.,.r.,.r..,.r.,..r.,..r.,..r.
Installation Instructions PLACEMENT OF THE MOUNTING REMOVING THE MICROWAVE OVEN FROM THE CARTON/ REMOVING THE MOUNTING PLATE []Remove tray bag,. the Do of front tile installation exhaust adaptor instructions, and the not tile Stxrofoam remoxe tile I-_ FINDING THE WALL STUDS i filter, glass small hardware I)r°tecting, PLATE i i tile o_,en. []Fold back all 4 carton sides, Then carefifll) onto the top side, tile Stx rofoam.
Installation DETERMINING Template beneath with flat bottom Instructions WALL PLATE LOCATION cabinet UNDER YOUR CABINET Template beneath cabinet with recessed bottom Trimthe rearwall template along the dotted line. II Trimthe rearwall templatealong the dotted line. I)raw a verticalline on the wall at the centerof the 30" to 36" wide space.Tapethe RearWall Template onto the wall matching the centerline andtouchingthe bottom of the cabinet. ...........
Installation DETERMINING Instructions REAR MOUNTING REAR ° o o o CAUTION: "_,_ar glo_es to axoid cutting finge_ on shaq) edges. o o o o o o o SCREW LOCATIONS WALl, o o o TEMPLATE o o o o o NOTE: The Rear Wall Template to position the bottom mounting to locate the horizontal exhaust _lJse a level to check a cct _I'_telv, that _ I,ocate and mark at least one stud on the lefi or right side of the centerline.
Installation INSTALLATION This the microwave following oven three A, Outside Top B, Outside Back C, Recirculating is designed types Exhaust TYPES fi>r adaptation Instructions (Choose A, B or C) to NOTE: of ventilation: (Vertical I_haust Duct) (Horizontal (Non-Vented microwave Exhaust type of ventilation proceed Duct) This Top (except to that is shiI)ped fl)r required assembled non-vented fl>r Outside models).
Installation Instructions OUTSIDE TOP EXHAUST INSTALLATION A1. A2. A3. A4. (Vertical Duct) OVERVIEW Attach Mounting Plate to _Mfll Prepare Top Cabinet Check Damper Operation Mount Microwave Oven A5. Ac!j ust Exha ust Adaptor A6. (_onnect Ductwork I-_ To use toggle ATTACH THE MOUNTING PLATE TO THE WALL bolts: Spacingfor Toggles MoreThanWall -,,,-I_,-,.-!_,_T hickness ToggleWings Mounting Plate ml, B01tEnd _ Remove the template fl'om the rear wall.
Installation I-_ Instructions I-_ USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET The top cabinet template will help you locate SUl)port screw holes, power cord and exhaust locations. INSTALL THE DAMPER (cont.) Dam the top outlet Reinstallrear retainingscrew " Close tile blower Fear scYew, cmer " Remove tape holding should pivot easily. with adaptor tile damper.
Installation MOUNT Instructions ADJUST THE EXHAUST ADAPTOR THE MICROWAVE OVEN (cont.) _]nsert a sell:aligning screw through top center cabinet hole. Temporarily secure tile oven by turning tile screw at least two full turns after tile threads have engaged. (It will be completely tightened later.) Be sure to keep power cord tight. Be careful not to pinch the cord, especially when mounting flush to bottom of cabinet. Open tile to connect top cabinet and ac!iust to tile house duct.
Installation Instructions OUTSIDE BACK EXHAUST INSTALLATION B1. B2. B3. B4. BS. B6. OVERVIEW Prepare Rear _4_dl Remove Exhaust Adaptor Attach Mounting Plate to Wall Prepare Top Cabinet Adapt Blower for Back Exhaust Motmt the Microwave Oven TEMP LATE . PREPARING THE REAR WALL FOR OUTSIDE BACK EXHAUST The rear wall template as shown on page 9. " Read the instructions TEMPI ,ATE. should be positioned accm'atel} on the REAR X4__I,I, • Cut the oi)enin_, following, REAR X,__I,I, TEMPI,ATE.
Installation I-_ Instructions ATTACH THE MOUNTING PLATE TO THE WALL USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET Tile top cabinet stlI)I)oFt Remove the template fl'om the rear wall. The mounting plate must be secured to tile wall using at least 3 toggle bolts and one wood screw. Tile wood screw must engage a wall stud, []Remove tile toggle wings fl'om scI'ew and * Read the instructions TEMPI,ATE. tile bolts.
Installation Instructions ADAPTING MICROWAVE BLOWER FOR OUTSIDE BACK EXHAUST (cont.) [] Carefllllv slide the and lift it partially blower wires handling the wires are ] enough to allow and place oi_ening, the in the blower top trait of the back into the microwave. right, blower motor toward the out of the opening. Note: long Tilt The flexible while perfimning these steps. Disconnect only if it is necessary fin" additional flexH)ilitv. CAUTION: Do unit Make wiring.
Installation Instructions CabinetFront MOUNT OVEN THE MICROWAVE CabinetBottomShelf FillerBlock to Depth ofquivalent Cabinet Recess T Self-AligningScrew FOR EASIER INSTAI,IATION AND PERSONAI, SAFETY, WE RECOMMEND THAT TWO PEOPLE INSTALL THIS MICROWAVE OVEN. NOTE: If vour cabinet around grolmnet cutting of tile tile We recommend fl'ont hangs using below IMPORTANT: ease thread through cord in bottom not oven filler to prevent blocks cabinet may 2 selt:aligning through holes.
Installation RECIRCULATING INSTALLATION Instructions (Non-VentedDuctless) OVERVIEW C1. Attach Mom_ting Plate to _Mdl C2. Prepare Top Cabinet C3. Check Microwave Assemblv C4. Adapt Blower tin" Recirculation C5, Mount the Microwave Oven C6, Install Charcoal Filter I-_ ATTACH THE MOUNTING PLATE TO THE WALL _ Place the motmting plate against the wall and insert the toggle wings into the holes in the wall to mount the plate.
Installation Instructions [] ADAPTING MICROWAVE BLOWER FOR RECIRCULATION _ ReIllO_e retaining the back screw. top center blower illOtoi" Carefiflly and slide blower wires hai_dling the wires dooI" the blower lift it partially out are motor of the long toward the opening. enough right, Note: to allow The flexible while perfimnii_g these steps. Disconnect OlflV if it is necessary fl)i" additional flexibility.
Installation Instructions NOTE: When motmting the ulicI'owa;'e oven, thread power cord through hole in bottom of top cabinet. Kee I) it tight ADAPTING MICROWAVE BLOWER FOR RECIRCULATION (cont.) ] place Tilt and oi)ening, in the the blower unit back top of the microwave, into the throughout Steps 1-3. Do not pinch cord or lifi oven by pulling cord. _ [] I,if* microwaxe, tilt it forward and hook slots at back bottom edge onto f0m" lower tabs of motmting CAUTION: unit wiring. pinched.
Installation Instructions MOUNT THE MICROWAVE OVEN (cont.) []Insert 2 self-aligning throuoh_ holes. each INSTALLING THE CHARCOAL FILTER ACCESSORY []Remove tile 3 screws along tile top fl'ont edge of tile oven using a #1 Phillips screwdriver. screws outer top cabinet TtlI'n two fllll ttlI'IlS on _] Open tile door. _ Remove the grille by sliding pulling it straight off. screw. it to the left and Charcoal _J_ []Tighten screw [] center completel).
Installation Instructions BEFORE YOU USE YOUR MICROWAVE -_] '27] I Make the microwaxe oxen has been installedsureaccording to instructions. Remoxe all )ackino IlliC I'OW_lX, e ox, en. _] Install [_ Replace turntable house and material ring fllse or mrn from the I in caxitx. breaker back on. IllIIIIIIII [_ lug power outlet. cord electrical into a dedicated 15- to 20-amp Ensure proper ground exists / before use 23 _ Read the Owner's Manual. [_ KEEP THE INSTAI,I,ATION INSTI_.
39-40425 10-04JR ] Printed [ in Malaysia DE68-02957A J