Installation guide

Installation Instructions
ADAPTING MICROWAVE
BLOWER FOR RECIRCULATION
_ ReIllO_e the back top center blower illOtoi" dooI"
retaining screw.
J
Blower Motor-- Back of
Microwave
Blower Door
Screw
[]Open the blower door b) lifting it up at the back
side of the microwaxe. Remo_e and saxe the top
and back retaining screws that hold the blower
illotor in the illiCi'OWa_,e.
Retaining
screw
Retaining
screw
[] Carefiflly slide the blower motor toward the right,
and lift it partially out of the opening. Note: The
blower wires are long enough to allow flexible
hai_dling while perfimnii_g these steps. Disconnect
the wires OlflV if it is necessary fl)i" additional
flexibility.
Backof
Microwave
_ Remoxe the two screws holding the gra) colored
inlet sleeve to the blower unit. Rotate the ora_
sleeve as shown tmtil the gra) arrow lines up with
the "R', Recirculating exhaust. Reinstall the two
scYews.
Remove screws from
Gray Inlet Sleeve
x__"
Back of Microwave
_Roll the assembled blower trait so that the
black-colored exhaust outlet laces the fl'ont of
the microwave and the gra._coh)red inlet sleeve
taces downward.
NOTE: The gra}-c )1 _red sleexe o )ening must
AI.\'_YS tace downward to ensure proper
opei'ation of the i//icrowa_e.
Must Face
Downward
Black
Exhaust
Outlet Facing
the Front
Backof
Microwave
2O