Installation guide

Installation Instructions
RECIRCULATING (Non-VentedDuctless)
INSTALLATION OVERVIEW
C1. Attach Mom_ting Plate to _Mdl
C2. Prepare Top Cabinet
C3. Check Microwave Assemblv
C4. Adapt Blower tin" Recirculation
C5, Mount the Microwave Oven
C6, Install Charcoal Filter
I-_ ATTACH THE MOUNTING
PLATE TO THE WALL
I
Remove the template flxnn the rear wall. The
motmting plate must be secured to the wall using
at least 3 toggle bolts and one wood screw. The
wood screw inust engage a wall stud.
_ Remove the toggle wings fl'om the bolts.
_ Insert the bolts into the motmting plate through
the holes designated to go into drywall and
reattach the toggle wings to sA" onto each bolt.
To use toggle bolts:
Spacingfor Toggles
MoreThanWall
+l._-,,-j_Thickness
ToggleWings
Mounting
Plate
if,
BoltEnd
_ Place the motmting plate against the wall and
insert the toggle wings into the holes in the wall
to mount the plate.
NOTE: Betore tightening the toggle bolts and the
wood screw(s), check again to be sure that the
motmting plate is level and centered left to right.
CAUTION: Be carefld to avoid pinching fingers
between the back of the motmting plate and the wall.
_ Tighten all bolts. Pull the plate away fl'om the
wall to hel I) tighten the bolts. Be carefld not to
ove>torque toggle bolts.
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
The top cabinet template will hel I) you locate the top
st/ppoI't screw holes and power cord CtlH)Ilt locations.
" Read the instructions on the TOP CABINET
TEMPI,ATE.
" Tape it tmderneath the top cabinet.
" Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: _4ear safet} goggles when drilling holes
in the cabinet bottom.