Installation guide

Installation Instructions
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST (cont.)
[] Carefllllv slide the blower motor toward the
right,
and lift it partially out of the opening. Note: The
blower wires are long enough to allow flexible
handling while perfimning these steps. Disconnect
the wires only if it is necessary fin" additional
flexH)ilitv.
Backof
Microwave
[] Remoxe the two screws holding the gray-colored
inlet sleexe to the blower trait. Rotate the gray
sleexe as shown until the gra)' arrow lines up with
the "B", back exhaust. Reinstall the two screws.
Remove screws from
Gray Inlet Sleeve _,.
Back of Microwave
_Roll the assembled blower trait so that the
black-colored exhaust outlet faces the back of
the microwave and the gray-colored inlet sleeve
faces downward. NOTE: The gray-colored sleeve
opening must AI._,_VS thce downward to ensure
proper operation of the microwave.
Must Face
Downward
Black
Exhaust
Outlet
Backof
Microwave
] Tilt and the blower trait back into theplace
oi_ening, in the top of the microwave.
CAUTION: Do not pull or stretch the blower
unit wiring. Make sure the wires are not
pinched.
_ Secure the blower unit to the microwaxe with
the two screws remoxed in Step 2.
Retaining
screw
Retaining
screw
[] Close the blower coxer.
[]Attach the exhaust adaptor to the rear of the
microwave b) sliding it into the guides at the
top center of the back of the oxen.
Adaptor
Backof
Microwave
Guide
Guide
BlowerMotor Screw
LockingTabs
Push in securely until it is in the lower locking
tabs. Take care to assure that the damper hinge
is installed so that it is at the top and that the
damper swings fl'eely. Reinstall the original
blower motor screw through the adaptor and
into the back of the microwave.
17