Installation guide

Installation Instructions
ADAPTING MICROWAVE
BLOWER FOR
RECIRCULATION (cont.)
] Tilt and the blower unit back into the
place
oi)ening, in the top of the microwave,
CAUTION: Do not pull or stretch the blower
unit wiring. Make sure the wires are not
pinched.
[]Secure the blower unit to the microwave with
the two screws removed in Step 2,
Retaining
screw
Retaining
screw
[]Close the blower cover and secure it with the
screw remoxed in Step 1.
MOUNT THE MICROWAVE OVEN
FOIl EASIER INSTAI,IATION AND PERSONAl,
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
NOTE: If vom" cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord,
NOTE: We recommend using filler blocks if the
cabinet fl'ont hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used, case
damage may occur from overtightening screws.
NOTE: When motmting
the ulicI'owa;'e oven,
thread power cord
through hole in bottom of
top cabinet. Kee I) it tight
throughout Steps 1-3. Do [] I,if* microwaxe, tilt
not pinch cord or lifi it forward and hook
oven by pulling cord. _ slots at back bottom
edge onto f0m" lower
tabs of motmting
l
_ Rotate fi'ont of o_en
up against cabinet
bottoin,
_]nsert a sell:aligning screw through top center
cabinet hole. Temporarily secm'e the oven by
turning the screw at least two full turns after the
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.
CabinetFront
CabinetBottomShelf
FillerBlock
i_oEquivalent to Depth
f CabinetRecess
Self-AligningScrew
MicrowaveOvenTop
21