Installation guide

Installation Instructions
I-_ ATTACH THE MOUNTING
PLATE TO THE WALL
Remove the template fl'om the rear wall. The
mounting plate must be secured to tile wall using at
least 3 toggle bolts and one wood screw. Tile wood
screw must engage a wall stud,
[]Remove tile toggle wings fl'om tile bolts.
[]Insert tile bolts into tile mounting plate through
tile holes designated to go into drywall and reattach
tile toggle wings to :_A"onto each bolt.
To use toggle bolts:
Mounting
Plate
,,i,(
Spacingfor TogglesMore
-,,-I-,H,-i-,,_ThanWall Thickness
i
ToggleWings
B01tEnd
_ Place tile motmting plate against tile wall and
insert the toggle wings into the holes in the wall
to I//Otlnt tile plate.
NOTE: Betm'e tightening the toggle bolts and the
wood screw(s), check again to be sure that the
motmting plate is level and centered left to right.
CAUTION: Be careflfl to awfid pinching fingers
between the back of the motmting plate and the wall.
_ Tighten all bolts. Pull the plate away fl'om the
wall to hel I) tighten the bolts. Be carefld not to
ove_=torque the toggle bolts.
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
Tile top cabinet template will hel I) you locate tile top
stlI)I)oFt scI'ew holes and poweI" coi'd Ctltotlt.
* Read the instructions on the TOP CABINET
TEMPI,ATE.
" Tape it tmderneath tile top cabinet.
" Drill the holes, fl)llowing the instructions on the
TOP CABINET TEMPLATE.
CAUTION: X_'ear satety goggles when drilling holes
in tile cabinet bottom.
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST
[] ReIllOXe tile back top center blower illotoi" dooI"
retaining screw.
J
of
BlowerMotor_ _.Microwave
BlowerDoor
Screw
_Open tile blower door it tile backb} lifting /l I)
at
side of the microwaxe. Remo_e and saxe the top
and back retaining screws that hold the blower
iilotoi" ill tile iilici'owa_e.
Retaining
screw
Retaining
screw
16