Installation guide

Installation Instructions
I-_ USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
The top cabinet template will help you locate the top
SUl)port screw holes, power cord and exhaust outlet
locations.
" Read tile instructions on tile TOP CABINET
TEMPLATE.
" Tape it tmderneath tile top cabinet.
" Drill the holes, fi_llowing the instructions on the
TOP CABINET TEMPLATE.
CAUTION: _4ear satety goggles when drilling holes
in tile cabinet bottom.
I-_ INSTALL THE DAMPER
Remove rear
retaining screw
" Place tile microwaxe in its ui)right position.
" Remo_e tile retainin,* screw at tile rear of tile
i/lotoi" door.
" I,ifl tile blower motor door,
" Slide the exhaust adaptor toward the left side and
into the opening,
" The adaptor should be oriented as shown,
I-_ INSTALL THE DAMPER (cont.)
Dam
Reinstallrear
retainingscrew
" Close tile blower cmer with adaptor and reinstall
Fear scYew,
" Remove tape holding tile damper. Tile damper
should pivot easily.
" Tile adaptor can be a(!justed, lett to right and fl'ont
to back, to align with the house exhaust ductwork,
13
_-'_ MOUNT THE MICROWAVE OVEN
FOR EASIER INSTAI,IATION AND PERSONAl,
SAFETY, X4E RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
NOTE: If yore" cabinet is metal, use tile nvhm
grommet aro/md tile power cord hole to prevent
cutting of tile cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are
not used, case damage may occur from
overtightening screws.
NOTE: When too/rating
the iilicrowave oven,
thread power cord
through hole in bottom of
top cabinet. Kee I) it tight
throughout Steps 1-3. Do
not pinch cord or lift
oven by pulling
_ I,ift microwaxe, tilt
it forward and hook
slots at back bottom
edge onto fo/ir lower
tabs of mounting
plate.
->.
_ Rotate front of
o_en
up against cabinet
bottoill.