Manual

%
Light Bulb Replacement
iI 40-wattincandescent
I To replace tile I/ull/, first
(liscolllle( t the l)(/wer ut
the main ills( or circuit
breaker panel or lmll
tile plug.
2 Remove tile screw ti'oln
light cox(r and lower
the co'_ ( r.
3 Be sure tile bulb is cool
l/elbre removing. After
breaking tile adhesive
seal, remove the bull) b_.
gently turning.
41Replace tile bull). Close
tfi_ light co_er and
secure tile co'_(r with tile
screw. Connect electrical
power to tile oven.
Remove Screw
ii Replace the burned,out
:: bulb with a 120 volt }
:: gO-watt incandescent
:bulbCwB3ax ooo3),
(: available from your
GE supplier.
1 "1"orepla( e the oxen light,
firs| dis(ol/lle(t the t)ower
at the ]//all/filse or (iF(flit
breaker panel or pull
the l)lug.
2 Remoxe the ti'ont grille l/v
backing out 01e 3 screws
along 0/e top, Slide 0/e
grille to the lefi, then pull
straight out.
32
3 Rel//ove tile chin:coal
/ilten if llresem. Reach
imo |fie opening, just
right of (enter. The light
bull) is lo(ated tleneath
a light comt)artmem
cover. Press and hold
the center snap while
lifiing tile tab on tile
left corllett Remove the
cover. Remove file bult/
1)y turning gently.
4 Install the relllacemeni
bull). Reins|all |fie
coml)artment co_er and
charcoal filter, if present,
Reinstall the ti'ont grille
panel with the 3 original
screws.
terior Li
Housing
5 (]Ol/l/ecl electri(al t)()_rer
to the ovell.