Installation guide
Installation Instructions
CHECK MICROWAVE ASSEMBLY
Exhausl Adaptor (absent
on models shipped fior
recirculation exhaust) \
• Place tile microwave in ils upright position, with the
top of the unit fbcing tip.
• The microwave oven m_y be shipped assembled fbr
top exhaust (adaptor instMled) or for recirculafion
exhaust (adaptor absent).
• lfthe microwave was shipped for recirculation
exhaust, skip lo C5. If shipped for lop exhaust,
proceed with C4.
ADAPTING MICROWAVE
BLOWER FOR RECIRCULATION
[] Remove [] Lift off the
and save blower plate
screw dmt and attached
holds blower adaplor from
plate to the microwave.
lnic rowave.
_Microwave
-. 7"
[] Slide exhaust adaptor m one side and remove it.
NOTE: The exhaust adaptor wilh damper is not
needed for recirculating models. Yon may want m
save them for possible future use.
_ Remove and the that holds the blower
save screw
inotor tO ltle microwave.
BIowerPlate
_, Careflfllypull out the blower unit. The wires,
will extend fbr enough to allow you to ad}ust the
blower uIfit.
[] Roll tile blower unit 90 ° so ltlat fan blade opeIfings
are fhcing toward the front of the Inicrowave.
R0tl
NOTE: Make sure wires reInain routed in the
grooves of the motor fl*ame.
2O