Installation guide

Installation Instructions
I-_ ATTACH THE MOUNTING
PLATE TO THE WALL
Atlach the plale lo lbe wall using toggle bolls.
At leaet one wood screw IIlUSt be used to attach
tile plate to a wall slud.
[]Remove llle toggle wings fYoIn tile bolts.
[]Insert tile bolts into tile mounting pla/e through
tile holes designaled to go into drywall and reattach
tile toggle wings m '-"/4"onto each bolt.
To use toggle bolts:
Mounting
Plate
Spacingfor TogglesMore
_-_ ThanWallThickness
ToggleWings
BoltEnd
[] Place the Inounting plate against the wall and
insert lhe toggle wings into the holes in the wall
to mount the plate.
NOTE: Before tighlening toggle bolts and wood
screw, make sure tile labs on lbe mounting plale
much tile bottom of the cabinet when pushed flush
against die wall and that lbe plate is properly
cen/ered under tile cabinet.
CAUTION: Be carefial to avoid pinching fingers
between die back of lhe mounting plate and die wall.
[] Tighten all bolts. Pull 1lie plme away from the wall
m help lighten the bolts.
I-_ USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for file top support screws mid
a hole large enough ff_r the power cord to fit through.
• Read the instructions on the TOP CABINET
TEMPLATE.
• "Pape it underneath the top cabinet.
• Drill the boles, tbllowing the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.
[_ ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST
[] ReIIlove arid that holds blower Iilotor
save screw
to Inicrowave.
Blower Motor
Backof
Microwave
-_ BlowerMotor
- _ Sc[ew
[] Carefiflly pull out the blower unit. Tile wires
will extend fhr enough to allow you to ad}ust tile
blower unit.
_End B
16