LARDER FRIDGE - MODEL RLA80, RLM80, RLS80 INSTRUCTIONS FOR INSTALLATION & USE GETTING STARTED: STEP 1 To ensure that your fridge runs reliably and efficiently follow these steps. STEP 2 STEP 4 Level the fridge by adjusting the front feet. This will stop rocking or vibration and keep the door aligned. NB. This is the responsibility of the customer. NB. The spanner is for illustration only and is not supplied with the fridge.
For Your Safety For your safety, read the following advice: The fridge cooling system contains a small amount of gas which is environmentally friendly but flammable. To avoid any risk :● SAFETY & INSTALLATION ● ● ● ● Install the fridge following the installation instructions and ensure that ventilation openings are kept clear of obstruction. Take care when installing or moving the fridge to avoid damaging the pipes on the rear.
Installation Location & Air Circulation 100mm (4 inches) Locate your fridge away from sources of heat e.g. cookers, radiators, direct sunlight as extreme temperature will affect its performance. SAFETY & INSTALLATION Allow a minimum 100mm (4 inches) between the top of the fridge and the ceiling or the underside of a wall cupboard. Providing you follow the recommended ventilation requirements you will :● Prolong the life of the fridge. ● Minimise the risk of condensation on the outside of the fridge.
Installation Stability bracket: WARNING: To prevent the fridge from tilting forwards, it must be held in place with the stability bracket supplied. This is the responsibility of the customer. SAFETY & INSTALLATION Fixed to the floor or wall at the rear of the fridge, the stability bracket hooks onto the compressor mounting plate holding the fridge secure. The stability bracket must be installed securely in accordance with these instructions BEFORE using the fridge.
Installation Levelling: Level the fridge when it is in its final location by adjusting the front feet, until firm contact is made with the floor. This will stop rocking or vibration and keep the door aligned which helps the fridge run reliably and efficiently. Note: Before plugging in and switching on, leave the fridge standing in its final location for at least 15 minutes to allow it to settle.
Installation Electrical Supply WARNING: This appliance must be earthed. SAFETY & INSTALLATION The appliance must be positioned so that the plug is accessible after installation. Fuses Your appliance comes fitted with a plug and a 13A fuse. If you need to replace the fuse, only use those rated at 13A and ASTA approved to BS1362. Changing the Plug Cut off and dispose of the supplied plug if it does not fit your socket.
Controls Controlling the Temperature of the Fridge Compartment The control wheel on the front of the worktop adjusts the internal fridge compartment temperature. The internal temperature should be 5˚C or colder although some sections such as the salad bins will be slightly warmer. The setting of the control wheel will depend on the location of the fridge, the room temperature and how often the door is opened. The normal set point (marked by a 3 and N on the dial) is usually suitable.
Useful Advice A A B B C USEFUL ADVICE D B Note: The Rating Plate, which lists the appliance Model Number and Serial Number can be found near the bottom of the interior wall. STORAGE ZONES 8 Zone Type Food Storage A Cool Dairy products, Cheese, butter, margarine, Low fat spreads, cooking fats / lards Preserves - Jam, curd, marmalade, spread, salad dressing or sauces.
Useful Advice Making the best use of your Fridge To ensure that your fridge operates as efficiently as possible : ● Follow food packaging “best before/use by” instructions or your suppliers advice on a suitable maximum storage time. ● Keep foods covered to retain moisture and prevent flavour/odour transference. Plastic bags, aluminium foil, plastic stretch wrap and containers with lids are ideal. ● Avoid opening the doors unnecessarily or for longer than needed.
Useful Advice Sealbreaker Grab Handle ● The sealbreaker grab handle is designed to move and act upon the door seal to ease door opening for the customer. USEFUL ADVICE Commodity and Bottle Racks Commodity racks can be repositioned in the door to + PIVOT suit your storage requirements. The lidded commodity rack is recommended for the storage of dairy items, such as butter, margarine and cheese. To remove, lift rack vertically to release from fixing supports.
Useful Advice Salad Bins For the storage of fruit, vegetables and salad items. When storing vegetables, remove unusable leaves and soil and leave lettuce, cabbage and cauliflower on the stem. It is advisable to clean the salad bin regularly, it can be removed by sliding it out from position. Note : Care must be taken to ensure that the salad bin is pushed in fully before shutting the fridge door.
Defrosting Defrosting No manual defrosting required The fridge compartment will defrost automatically. During defrost periods water droplets form on the interior back wall of your Larder Fridge and refreeze afterwards. CLEANING & MAINTENANCE WARNING: Ensure that stored food does not come into contact with the interior back wall of your Larder Fridge. Also ensure the defrost gutter drain hole is kept clear, see ‘Cleaning’ in the CLEANING & MAINTENANCE section.
Cleaning Cleaning WARNING: Switch off electrical supply and pull out mains plug before cleaning. Interior Note : We recommend you use a straw to keep the defrost gutter drain hole clear of any blockage. DO NOT use sharp metal tools which could cause damage beyond repair. WARNING: Do not use abrasive powder, household cleaner, bleach or wax polish to clean the interior, they will leave a smell in the fridge. 1.
Maintenance Going Away If you are going away and don’t want to use your fridge, switch off the electricity supply and pull out the mains plug. Remove food and follow the cleaning instructions on the previous page. Note : Leave the door ajar to prevent an accumulation of odours.
Door Reversal Door Reversal You will need a cross head screwdriver, a flat blade screwdriver and a 5mm spanner to carry out this procedure. Our Service Department can arrange for an Engineer to do the conversion for you but a charge will be made. WARNING: Switch off electrical supply and pull out the mains plug. Remove all door furniture and all loose items/fittings from inside the fridge.
Door Reversal 14. 15. seal stop 16. Use a screwdriver to remove the door stop from the bottom right of the door and refit on the bottom left. 17. Refit the seal stops, one top right the other bottom right. Push into position and secure with fixing screw. 18. 19. 20. 21. CLEANING & MAINTENANCE With the door furniture removed carefully lie the door onto its interior lining. We recommend that you lie the door onto a suitable protective material (ie. the original packaging).
Troubleshooting IS THE FRIDGE WORKING AS YOU WANT? Have you read through the instruction book ? If you still have a problem, before calling our service organisation see if any of the tips below help. The fridge will not work 1. Check plug is firmly positioned in the socket outlet and the power supply is switched on. 2. Check power supply with another appliance. 3. Check fuse/circuit breaker. 4. Check the door is closed properly. The fridge is making a lot of noise 1.
Hotpoint guarantee “Satisfaction guaranteed or your money back” We give you a unique ‘satisfaction guaranteed’ promise - valid for 90 days - after you have purchased your Hotpoint appliance. If there is a technical problem simply call Hotpoint Repair service or visit our web-site at www.theservicecentre.co.uk and where necessary, we will arrange for an engineer to call. If the technical problem is not resolved under this guarantee, we will replace your machine or, if you prefer, give you your money back.
After Sales Service “No company is better positioned to offer an after sales service on a Hotpoint appliance than us - the manufacturer” As part of our commitment to you, all Hotpoint appliances have the added benefit of a fully inclusive parts and labour guarantee for the first 12 months. In addition to this you also have the advantage of free replacement parts for the first 5 years when fitted by a Hotpoint engineer.
Key Contacts After Sales Service Over 1200 trained specialists, directly employed by us, ensure that you can have complete confidence in both the appliances and services we offer. Repair Service and Information Desk UK: 08709 066 066 (Open 8 to 8 Mon - Fri, 8 to 6 Sat, 10 to 4 Sun & Bank Holidays) www.theservicecentre.co.