Owner's Manual

10
REMOVE EXHAUST ADAPTOR
If exhausting/venting using the 3
1
ø4s x 10s rectangular
GXFW³RSWLRQDOIRU-9-9-9-9-9
DQG-9PRGHOVRQO\
5HPRYHWKHH[KDXVWDGDSWRUIURPWKHLQVLGHRIWKHKRRG
Set it aside along with its mounting screws.
3
1
ø4s[s
rectangular
H[KDXVW
adaptor
and screws
REMOVE FILTER
Remove the shipping tape holding the metal grease
filter in place. Pull down on the center of the front edge
of the filter. The filter will then slip out of the retaining
tabs on the back.
REVERSE THE BAFFLE FOR
DUCTED INSTALLATIONS ONLY
-9
-9-9-9DQG-9PRGHOV
,IWKHKRRGLVWREHUHFLUFXODWHGVNLSWRWKHQH[WVWHS
Remove the baffle from the top of the hood. Reinstall
the baffle so the short side marked “VENTED” is visible.
The long side of the baffle should be inside the hood.
REMOVE WIRING COVER
Remove the wiring cover from inside the hood.
Set the cover and its mounting screws aside.
Wiring
cover
REMOVE WIRING KNOCKOUT
Remove either the top or the back wiring knockout as
needed and install an approved strain relief clamp.
2
3
4
5
6
Metal grease filter
Installation Instructions
“VENTED” is visible
Strain relief
clamp
Back
knockout
Top
knockout
Strain relief
clamp
REMOVE DUCT KNOCKOUT
If recirculating, non-vented ductless (JN327 and RN328,
and optional for JV247, JV248, JV347, JV348 and JV367
models only), skip to Step 11 D and proceed.
Using a flat-blade screwdriver, remove the appropriate
duct knockout from the top or back of the hood.
3
1
ø4s x 10s Rectangular
vertical discharge.
Remove top rectangular
duct knockout only.
7s Round vertical discharge.
Remove circular duct
knockout only.
3
1
ø4s x 10s Rectangular horizontal
discharge. Remove rear
rectangular duct knockout only.
7