GTD33EASK GTD33GASK GTD33PASK GTD42EASJ GTD42GASJ GTD45EASJ GTD45GASJ GTD65EB GTD65GB GTD75EC GTD75GC GTX22EAS GTX22GA GTX33EA GTX33GA GTX42EA GTX42GA GTX52EAS GTX52GAS GTX65EB GTX65GB HTX21EA HTX21GA HTX21PA HTX24EA HTX24GA

19
Installation Instructions
REVERSING THE DOOR
B
REVERSING THE DOOR - GLASS
PANEL DOOR MODELS
1
Open the door approximately 130 degrees. With a
putty knife, remove the 4 plastic caps located
along the left side of the front panel and set them
aside.
2
Remove the bottom screw from each hinge (right
side) and partially insert them into each top hinge
hole on the left side.
NOTE: All 4 front panel hinge screws will now be
in the top hinge holes - 2 on the left and 2 on the
right.
3
Loosen each top hinge screw on right side.
Remove the door and place it on a protective flat
surface to avoid any damage.
Plastic Cap (4)
Left side of
front panel
Loosen each
top hinge screw
on right side
B
REVERSING THE DOOR - GLASS
PANEL DOOR MODELS (cont.)
4
Remove both the blind plate and the striker plate
and install them in the opposite positions.
5
Remove the 4 door hinge screws, 6 inside screws
and 2 pocket screws. Lift the inner door upwards
using a flat blade screwdriver.
Blind
plate
Striker
plate
Inner door
Outer door
Inside
screws
Inside
screws
Pocket screws
Inside
screw
Door
hinge
screws